Chiral phosphoric acids (CPAs) are among the most frequently used organocatalysts, with an ever-increasing number of applications. However, these catalysts are only obtained in a multistep synthesis and are poorly recyclable, which significantly deteriorates their environmental and economic performance. We herein report a conceptually different, general strategy for the direct immobilization of CPAs on a broad scope of solid supports including silica, polystyrene, and aluminum oxide. Solid-state catalysts were obtained in high yields and thoroughly characterized with elemental analysis by inductively coupled plasma-optical emission spectrometry (ICP-OES), nitrogen sorption measurements, thermogravimetric analysis, scanning transmission electron microscopy/energy-dispersive X-ray spectroscopy (STEM/EDX) images, and solid-state NMR spectroscopy. Further, the immobilized catalysts were applied to a variety of synthetically valuable, highly stereoselective transformations under batch and flow conditions including transfer hydrogenations, a Friedländer condensation/transfer hydrogenation sequence, and Mannich reactions under cryogenic flow conditions. Generally, high yields and stereoselectivities were observed along with robust catalyst stability and reusability. After being used for 10 runs under batch conditions, no loss of selectivity or catalytic activity was observed. Under continuous-flow conditions, the heterogeneous system was in operation for 19 h and the high enantioselectivity remained unchanged throughout the entire process. We expect our approach to extend the applicability of CPAs to a higher level, with a focus on flow chemistry and a more environmentally friendly and resource-efficient use of these powerful catalysts.
As conventional power plants are decommissioned, an efficient dispatch of reactive power compensators is required to maintain transmission grid voltages within their limits. To evaluate the efficiency, a detailed analysis of reactive power flows among compensators, branches and loads is required. Reactive power loop flows (RPLFs) between two compensators are often unnecessary and hence their detection and minimization increases the efficiency of the reactive power dispatch. This paper presents a new method to detect and reduce RPLFs. First, reactive flows are evaluated and classified into different categories using power flow decomposition (PFD). On the basis of detected RPLFs, sensitivities are used to determine new control settings for different compensation technologies. A significant share of RPLFs is detected and reduced for an exemplary application on a synthetic transmission grid model. Despite numerous corrective control adjustments, voltage profile and grid losses change only slightly, thus showing the effectiveness of the presented method.