This work focuses on an experimental and numerical investigation into monitoring damage in a cube-shaped concrete specimen under compression. Experimental monitoring uses acoustic emission (AE) signals acquired by two independent measurement apparatuses, and the same damage process is numerically simulated with the lattice discrete element method (LDEM). The results from the experiment and simulation are then compared in terms of their failure load, final configurations, and the evolution of global parameters based on AE signals, such as the b-value coefficient and the natural time approach. It is concluded that the results from the AE analysis present a significant sensitivity to the characteristics of the acquisition systems. However, natural time methods are more robust for determining such differences, indicating the same general tendency for all three data sets.
This work focuses on analyzing acoustic emission (AE) signals as a means to predict failure in structures. There are two main approaches that are considered: (i) long-range correlation analysis using both the Hurst (H) and the detrended fluctuation analysis (DFA) exponents, and (ii) natural time domain (NT) analysis. These methodologies are applied to the data that were collected from two application examples: a glass fiber-reinforced polymeric plate and a spaghetti bridge model, where both structures were subjected to increasing loads until collapse. A traditional (AE) signal analysis was also performed to reference the study of the other methods. The results indicate that the proposed methods yield reliable indication of failure in the studied structures.
This paper applies the Acoustic Emission (AE) Technique to analyze the damage process in a one-meter span bridge model that was built from spaghetti sticks during a loading test. The AE signals are analyzed in terms of four coefficients that are evaluated as predictors of structure failure, with frequency variation appearing to be the strongest indicator of instability. The AE data are also compared to theoretical predictions that are given by the Bundle Model, confirming that underlying general patterns in damage processes are highly influenced by the geometric distribution of the structure and the loading pattern that is applied to it.
This paper discusses the combined application of the lattice discrete element method (LDEM) and the acoustic emission (AE) technique to analyze damage in quasi-brittle materials. These methods were used to study the damage in a concrete slab under pure-shear stress and a pre-fissured sandstone beam subjected to three-point bending. The first test was restricted to simulation results, whereas the second included experimental data. The discrete element method was used to perform the simulations for both tests, whereas the corresponding results and the information from the experiments were assessed using AE analysis tools. It was shown that the synergistic use of these two methods led to a comprehensive understanding of the two analyzed cases and offered an effective, generalizable approach for assessing damage processes in quasi-brittle materials.
25 April 2022 in Journal of Mechanisms and Robotics
This work reports advances in enabling the use of pneumatic artificial muscles (PAM) as an alternative to electromechanical actuators in upper-limb prostheses to take advantage of their low weight, clean, renewable energy source, and force compliance, which is especially suitable for interactions between machines and humans. It describes the model, simulation, and control of a 3-degrees of freedom (DOF) mechanism representing a prosthetic finger using PAM actuators. Its main contribution is the combination and expansion of classic nonlinear models and control methods for robotic systems to allow PAM actuators in the intended application, especially regarding transient effects in the generation of PAM forces. The effectiveness of the proposed mechanism and its associated controller is verified through both numeric simulations and experimental results.
10 April 2021 in Journal of the Brazilian Society of Mechanical Sciences and Engineering