Choon-Lai Tan

Choon-Lai Tan

Auto-generated profile, based on publicly available information

Choon-Lai Tan

Department of Mechanical and Aerospace Engineering, Carleton University, 1125 Colonel By Drive, Ottawa, ON, K1S 5B6, Canada

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2012 in Engineering Analysis with Boundary Elements
Verified
Journal Article
Closed access
Yui-Chuin  ShiahYui-Chuin Shiah
Yui-Chuin Shiah
CTC.L. Tan
C.L. Tan
CWC.Y. Wang
C.Y. Wang

15 March 2006 in Fatigue & Fracture of Engineering Materials & Structures
Verified
Journal Article
Closed access
PDF file
PSP. D. Shah
P. D. Shah
CTC. L. Tan
C. L. Tan
Xin WangXin Wang
Xin Wang

1 October 2012 in International Journal of Solids and Structures
Verified
Journal Article
Closed access
Yui-Chuin  ShiahYui-Chuin Shiah
Yui-Chuin Shiah
CTC.L. Tan
C.L. Tan

1 July 2006 in International Journal of Fracture
Verified
Journal Article
Closed access
PDF file
JYJ. Yu
J. Yu
CTC. L. Tan
C. L. Tan
Xin WangXin Wang
Xin Wang

8 January 2006 in Journal of Pressure Vessel Technology
Verified
Journal Article
Closed access
PDF file
APAnthony P. Parker
Anthony P. Parker
CTChoon-Lai Tan
Choon-Lai Tan
Fatigue and leak-before-break calculations for a pressure vessel require knowledge of the stress intensity factor at the deepest point of a straight- or curved-fronted (semi-elliptical) surface crack emanating from the bore of an internally pressurized, autofrettaged thick cylinder. A limited number of available solutions is curve fitted. The concept of a tube equivalent plate (TEP), which exhibits crack-constraint characteristics matching those of a thick cylinder, is developed, and the resulting equations are curve fitted. Ratios of the TEP stress intensity factor results are then used to interpolate between certain existing solutions. This provides wide-ranging solutions covering radius ratios from 1.8 to 3.0, autofrettage overstrain from 0 to 100% and crack shapes from straight fronted to semi-circular. The calculation procedure is described using worked examples.

10 September 2012 in Journal of Pressure Vessel Technology
Verified
Journal Article
Closed access
PDF file
KPKirsten Plante
Kirsten Plante
CTChoon-Lai Tan
Choon-Lai Tan
The boundary element method is employed to determine polynomial influence coefficients of stress intensity factors, KI, for a semi-elliptical crack in internally pressurized thick-walled curved tubing. Numerical results of these coefficients are obtained for a wide range of geometric parameters; they are the bend radius ratio, cross-sectional radius ratio, angular extent of the bend, and relative crack depth. The use of influence coefficients allows KI solutions to be determined for different load cases without repetitive 3D stress analysis of the cracked body. This is demonstrated for the case of autofrettage where the effects on KI of the residual stresses arising from it are presented.