Estimating thermal conductivity of snow, firn, and porous ice is key for modeling the thermal regime of alpine and polar glaciers. Whereas thermal conductivity of snow was widely investigated, studies on firn and porous ice are very scarce. This study presents the effective thermal conductivity tensor computed from 64 3‐D images of microstructures of snow, antarctic firn, and porous ice at −3, −20, and −60°C. We show that, in contrast with snow, conductivity of firn and porous ice correlates linearly with density, is approximately isotropic, and is largely impacted by temperature. We report that performances of commonly used estimates of thermal conductivity vary largely with density. In particular, formulas designed for snow lead to significant underestimations when applied to denser ice structures. We present a new formulation to accurately estimate the thermal conductivity throughout the whole density range, from fresh snow to bubbly ice, and for any temperature conditions encountered in glaciers.
1 January 2019 in International Journal of Fatigue
Understanding the slow densification process of polar firn into ice is essential in order to constrain the age difference between the ice matrix and entrapped gases. The progressive microstructure evolution of the firn column with depth leads to pore closure and gas entrapment. Air transport models in the firn usually include a closed porosity profile based on available data. Pycnometry or melting–refreezing techniques have been used to obtain the ratio of closed to total porosity and air content in closed pores, respectively. X-ray-computed tomography is complementary to these methods, as it enables one to obtain the full pore network in 3-D. This study takes advantage of this nondestructive technique to discuss the morphological evolution of pores on four different Antarctic sites. The computation of refined geometrical parameters for the very cold polar sites Dome C and Lock In (the two Antarctic plateau sites studied here) provides new information that could be used in further studies. The comparison of these two sites shows a more tortuous pore network at Lock In than at Dome C, which should result in older gas ages in deep firn at Lock In. A comprehensive estimation of the different errors related to X-ray tomography and to the sample variability has been performed. The procedure described here may be used as a guideline for further experimental characterization of firn samples. We show that the closed-to-total porosity ratio, which is classically used for the detection of pore closure, is strongly affected by the sample size, the image reconstruction, and spatial heterogeneities. In this work, we introduce an alternative parameter, the connectivity index, which is practically independent of sample size and image acquisition conditions, and that accurately predicts the close-off depth and density. Its strength also lies in its simple computation, without any assumption of the pore status (open or close). The close-off prediction is obtained for Dome C and Lock In, without any further numerical simulations on images (e.g., by permeability or diffusivity calculations).