Many factors affect the efficiency of photovoltaic panels (PV), which convert solar energy directly into electrical energy. Among these factors, temperature is one of the most important one. While some of the radiation from the sun is converted into electrical energy, part of it emerges as heat energy. This causes the photovoltaic cells to heat up and reduce their electrical efficiency. Different methods are used in the literature to reduce the temperature in PV panels. In this study, in order to reduce the adverse effects caused by the high temperature in the PV panels, 30 Thermoelectric Generators (TEG) were applied to the back surface of the PV panel to increase the PV panel output power and to produce additional electrical energy. Energy and exergy analysis made on the data obtained from both PV panels in the climatic conditions of the installation site showed that the temperature of the PV panel is reduced, and the energy and exergy efficiency is increased with the TEG application. At the end of July, August, and September, when the experiments were carried out, an average of 8.4% more electrical energy was obtained from a single PV panel with TEG, compared to the standard PV panel. Our results suggests that combination of TEG with PV panels could significantly increase the electrical energy, especially when a series of PV panels are used together.
1 December 2007 in Food Science and Technology International
In this study, drying behaviour of rough rice stacks up to 30 cm is simulated with several models. The suitability of models is determined by the statistical analysis by examining the values of correlation coefficient, standard deviation and mean squared deviation. The results showed that the best model to explain the drying characteristics of rough rice stack is the Midilli et al. model and the coefficients and exponent in the Midilli et al. model could be expressed as functions of drying temperatures and stack height. Statistical analyses also showed that among the models with two coefficients, that of Page, and among the models with three coefficients, that of Verma et al. and diffusion approach were acceptable models in expressing the drying behaviour of rough rice in stacks. Among the models considered here, the geometric model appeared to be the worst fit.
31 May 2021 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
This study deals with the estimation of power output and also thermodynamic analysis of two different photovoltaic panels. One of the panels is a standard photovoltaic module without fins (SPV), and the other one is a photovoltaic module with fins (FPV). First, a multi-layer feed-forward neural network structure is designed to estimate the daily power produced by photovoltaic modules. Furthermore, energy and exergy analyses were carried out to compare the performance of SPV and FPV panels. According to the thermodynamic analysis results using the experimental data obtained for two days (July 3, 2020 and August 4, 2020), it was calculated that the energy efficiency increased by a maximum of 8.77% and the exergy efficiency increased by a maximum of 25.9% in the FPV panel compared to the SPV panel. Moreover, considering the data obtained for each day during three months (July, August, and September), the total energy production increase in the FPV panel is approximately 6.7% compared to the SPV panel.
Fosil kaynakların sınırlı rezervleri, fiyatlarındaki dalgalanmalar ve çevreye verdikleri zarar, ülkeleri birincil enerji kaynaklarına alternatif arayışlarına yöneltmiştir. Sınırsız ve çevre dostu bir kaynak olan güneş enerjisi, diğer enerji kaynaklarına göre güçlü bir alternatiftir. Avrupa Birliği ülkelerinin büyük çoğunluğu güneş enerjisinden elektrik üretiminde tüketicilere birçok teşvik mekanizması ile çeşitli fırsatlar sunmakta ve yaygın olarak kullanılmasını sağlamaktadır. Dünyanın pek çok yerinde; güneş, rüzgâr, hidrojen ve jeotermal gibi yenilenebilir enerji kaynaklarına olan ilgi de artmaktadır. Tüm bunların yanında, alternatif enerji kaynaklarının kullanılması ve enerji eldesinin daha verimli hale getirilmesi için araştırmalar devam etmektedir. Güneş enerjisinden elektrik eldesi için gerekli olan ışınım değeri, gün içindeki hava durumuna ve mevsim özelliklerine göre değişmektedir. Güneş enerjisi santrallerinin kurulduğu bölgedeki iklim koşulları, fotovoltaik panellerden elde edilecek çıkış gücünü ve enerji maliyetini doğrudan etkiler. Çevresel şartlara göre fotovoltaik panellerden üretilen çıkış gücünün tahminlenmesi, güneş enerji sistemlerinin kurulumunda şirketlere rehberlik etmesi, maksimum enerji eldesi, enerjinin yönetimi ve sistemin verimli çalıştırılabilmesi için büyük önem arz etmektedir. Bu çalışmada, kurulumu yapılan fotovoltaik panellerden elde edilen veriler (Sıcaklık, Nem, Basınç, Işınım) kullanılarak güç değerlerinin tahminlenmesi için ileri beslemeli geriye yayılımlı yapay sinir ağları ve KNN (K-Nearest Neighbors) yöntemleri kullanılmıştır. Böylece gerçek saha şartlarında elde edilen panel değerleri her iki yöntemle de eğitilerek sonuçları karşılaştırılmıştır. Sonuç olarak panelin güç değerleri en yüksek %98.7945 doğrulukla geliştirilen yapay sinir ağı modeli kullanılarak sınıflandırılmıştır. Bu çalışma kapsamında geliştirilen güneş enerjisi tahmini için kullanılan makine öğrenmesi modellerinin yüksek performansa sahip olduğu ve gerçek değerlere çok yakın sonuçlar üretebildiği görülmüştür. Ayrıca belirlenen yük talebine göre farklı özelliklere sahip lokasyonlarda geliştirilen her iki yapay zekâ modelinin de kullanılabileceği sonucuna varılmıştır.
Merkezi İşlem Birimi'ndeki (CPU) aşırı sıcaklık artışı nedeniyle, bilgisayarlar zamanla kapanma ve sistem hasarları meydana gelmektedir. Bu çalışmada, CPU'daki sıcaklığı azaltmak amacıyla yeni bir termoelektrik soğutma sistemi tasarlanmıştır. Ayrıca sistemin dinamik kontrolü için 3 farklı yapay zeka modeli oluşturulup başarıları karşılaştırılmıştır. Yeni soğutma sistemi, termoelektrik modül kullanılarak tasarlanmıştır. Sisteme eklediğimiz termoelektrik soğutucu ile CPU arasındaki sıcaklık farkından faydalanarak fazla ısıyı iletim ve konveksiyon yoluyla uzaklaştırmaktır. Termoelektrik soğutucunun sıcaklığı her zaman CPU sıcaklığından düşük olacağından dolayı etkin soğutma sağlanmış olacaktır. Soğutma ünitesinin kontrolü için özel bir elektronik devre ve yazılım geliştirilmiştir. Ek soğutma sistemini dinamik olarak kontrol etmek için üç farklı yapay zeka modeli (yapay sinir ağı, rastgele orman ve k-en yakın komşu) oluşturulup başarıları karşılaştırılmıştır. Yapay zeka, termoelektrik soğutma sisteminin gücünü ve fan hızını belirler. Bu kontrolü belirli bir CPU yükü veya belirli bir sıcaklık değeri yerine tüm parametreleri (CPU frekansı, voltajı, işlem sayısı gibi farklı değerler) değerlendirerek gerçekleştirir. Maksimum yükte CPU sıcaklığı 41⁰C iken, tasarlanan termoelektrik soğutma sistemi sayesinde bu sıcaklık 31⁰C'ye düşürülmüştür. Tüm yöntemler eğitimde yüksek bir sınıflandırma başarısı sağlamıştır. Ancak yapay sinir ağı yönteminin sınıflandırma başarısı (%97,973) rastgele ormana (%97,297) ve k-en yakın komşuya (%96,306) göre daha yüksektir.