Project "Devils’ town Erosion MONITORing - DEMONITOR" involves the monitoring of accessible earth pillars in the area of Devil’s town, by using a combination of several non‐invasive methods. Terrestrial laser scanning (TLS) and photogrammetric imaging with unmanned aircraft (UAV) as a platform showed as great solutions for 3D modeling of this site and erosion monitoring. In this work it is shown that using manual free flight mode for imaging with UAV gave much better results than the missions performed with predefined flight plans. The desired long‐term effect from this research should have a significant part in the overall socioeconomic development of the municipality of Kuršumlija, and the entire Toplica district.
The correct conclusion about the assumptions concerning some phenomena can be obtained only through scientific analysis of statistical data. The scientific procedure of verifying a hypothesis using measurement results is called a statistical test. Depending on whether the hypotheses about the parameters in the feature distribution are tested or the distribution as a whole is tested, a parametric or non-parametric test is selected. The most significant representatives of parametric tests are the Probability Ratio Test, the Neumann - Pearson Lemma and the Bootstrap method, while the Pearson x2 test and the Kolmogorov test are presented as representatives of nonparametric tests. The paper presents the theoretical basis of some methods used in construction of statistical tests with given examples in geodesy.
In the new hall of the Institute for Materials and Structures, there was a need to control the geometry of the existing crane rails. In this paper, the methodology for determining the geometry of such a complex structure is presented, and the results of the applied method are also presented. The final product, i.e. the examined geometry of crane rails included numerical and graphical analysis of straightness, analysis of parallelism and analysis of horizontality of crane rails.
The detection of erosion was carried out on a characteristic rocky pillar, with the localization and quantification of differences between two surfaces. For this purpose, based on the defined area and spatial configuration of the scanning object, scanner positions, arrangement of control points, and appropriate spatial scanning resolution were planned. The spatial resolution of the point cloud is 1 cm, with a standard deviation of individual points up to 3 mm. Based on the collected data, registration of adjacent scenes was performed using typical scanner signals and the surface matching method. Georeferencing of the second epoch was carried out using the surface matching method. Locations where erosion of the rocky mass occurred were detected, amounting to 0.036 m³ (36 dm³).