1 January 2016 in Advances in Materials Science and Engineering
In order to save limited natural resources by utilising industrial by-products, this paper focuses on an entirely new application of fluidized bed combustion fly ash (FBCFA) into Portland composite cements. It is not currently used because undesirable ettringite, 3CaO·Al2O3·3CaSO4·32H2O, is formed during the hydration of FBCFA. Although the stability of ettringite has been the subject of much research, the solution is not yet fully clear. Ettringite is generally considered to be stable up to a temperature of 110°C; however, some investigators claimed that ettringite may already decompose at even ambient temperatures. To prove these statements, ettringite was prepared by the hydration of ye’elimite, 3CaO·3Al2O3·CaSO4, and the system stored at laboratory temperature in two environments: in laboratory settings and in an environment of saturated water vapour. The mineralogical composition of ettringite was long term (up to 160 days of hydration) and was analysed by X-ray diffraction (XRD) and differential thermal analysis (DTA). The hydration of ye’elimite is a relatively complex process. Only approximately 30% of ettringite was formed under laboratory conditions that appeared to gradually convert into metaettringite. Within an environment of saturated water vapour, we observed the conversion of ettringite into monosulfate. Original ye’elimite was indicated as the dominant phase of both storages.
1 July 2020 in Journal of Crystal Growth
11 August 2014 in Advanced Materials Research
This work is the opening chapter of the study that deals with products of degradation, which might form in hardened cement paste after exposure to sulphate attack. The article deals with ettringite preparation design and then with the realisation of this design
15 January 2018 in Key Engineering Materials
This paper deals with the verification of the possibility of preparing synthetic ettringite in a way of direct addition of aluminum sulfate and calcium hydroxide as an alternative to the hydration of yeelimite. The stability of the resulting system was studied using the X-ray diffraction (XRD) and differential thermal analysis (DTA) in two different environments, namely in a laboratory environment and the environment of saturated water vapour. The evaluations of X-ray diffraction analysis and thermal analysis show that in the ettringite sample stored in the laboratory environment, evaporation of molecular water and subsequent transformation of ettringite into metaettringite or monosulfate can occur over time. Conversely, exposition of saturated water vapour environment can lead to saturation of the system by free calcium ions due to the slow dissociation of calcium carbonate, and thereby increase the amount of ettringite at the expense of gypsum and aluminum amorphous phase. To verify the above, it is recommended long-term monitoring of samples exposed in monitored environments.
21 October 2014 in Advanced Materials Research
The article deals with preparation of Portland cements from raw material powder with reduced carbonated component. This component is replaced with fluidised fly ash. With prepared model cements tests of basic technological properties were carried out.
11 August 2016 in Materials Science Forum
The work aims to study the behaviour of blended cement with fluidized filter ash (FFA) considering to formation of the increased proportion of ettringite and its eventual transformation into thaumasite. In part of an experiment there were prepared three cements, two of them served as a reference one-component and the reference blended cement with limestone, a third one was tested blended cement with a FFA. All three cements were put to determination of basic technological properties and next they were observed during hydration process.