1 July 1996 in Physical Review E
In this paper, we report a generalized form for the range parameter governing the pair interaction between soft ellipsoidal particles. For nonequivalent uniaxial particles, we extend the Berne-Pechukas Gaussian overlap formalism to obtain an explicit expression for this range parameter. We confirm that this result is identical to that given by an approach that is not widely recognized, based on an approximation to the Perram-Wertheim hard-ellipsoid contact function. We further illustrate the power of the latter route by using it to write down the range parameter for the interaction between two nonequivalent biaxial particles. An explicit interaction potential for nonequivalent uniaxial particles is obtained by importing the uniaxial range parameter result into the standard Gay-Berne form. A parametrization of this potential is investigated for a rod-disk interaction. © 1996 The American Physical Society.
12 September 2005 in Reports on Progress in Physics
2 October 2001 in Modelling and Simulation in Materials Science and Engineering
1 October 1997 in Physical Review E
In this paper we present results from molecular dynamics simulations performed using a system of Gay-Berne particles confined between two substrates in a slab geometry. We use a nonseparable anisotropic molecule-substrate interaction potential and investigate weak and moderate molecule-substrate coupling strengths. We find that for both coupling strengths a well-defined, tilted molecular layer forms at each wall and that the pretilt angle and layer density are only weakly dependent on temperature as the central region is cooled through isotropiclike and nematiclike regions. The orientationally ordered fluid formed at the center of the film is tilted in sympathy with the surface layers. At low temperatures, however, where the central region adopts a layered arrangement, a sharp change is observed in the pretilt angle. This transition is more marked in the weak-coupling system where the high-temperature tilted surface layers adopt an approximately planar arrangement at low temperatures and the system resembles a bookshelf-geometry smectic film. In the moderate-coupling system, the surface layers maintain some tilt in the presence of the layered central region, leading to a smectic-stripe phase arrangement.
10 December 2009 in Physical Chemistry Chemical Physics
This paper presents the first examination of the potential for bicontinuous structures such as the gyroid structure to produce high efficiency solar cells based on conjugated polymers. The solar cell characteristics are predicted by a simulation model that shows how the morphology influences device performance through integration of all the processes occurring in organic photocells in a specified morphology. In bicontinuous phases, the surface defining the interface between the electron and hole transporting phases divides the volume into two disjoint subvolumes. Exciton loss is reduced because the interface at which charge separation occurs permeates the device so excitons have only a short distance to reach the interface. As each of the component phases is connected, charges will be able to reach the electrodes more easily. In simulations of the current–voltage characteristics of organic cells with gyroid, disordered blend and vertical rod (rods normal to the electrodes) morphologies, we find that gyroids have a lower than anticipated performance advantage over disordered blends, and that vertical rods are superior. These results are explored thoroughly, with geminate recombination, i.e. recombination of charges originating from the same exciton, identified as the primary source of loss. Thus, if an appropriate materials choice could reduce geminate recombination, gyroids show great promise for future research and applications.
10 May 2001 in Journal of Physics: Condensed Matter