30 November 2021 in IEEE Transactions on Transportation Electrification
An effective battery thermal management system (BTMS) is of great significance to ensure the safety and efficiency of lithium-ion batteries (LIBs). Both the temperature properties and lightweight are essential to the BTMS in electric vehicles. To fulfill these targets, a direct contact liquid-cooling system with multichannel is designed for the LIB module, and the simulation model is established and validated experimentally. The single-factor analysis is performed to explore the individual influence of different variables, and the comprehensive effect is conducted by the gray relational analysis. Furthermore, three surrogate models, including the response surface model, the Gaussian process model, and the radial basis function model, are conducted to parameterize the temperature behavior. On this basis, the multiobjective optimization functions are established and optimized by considering the maximum temperature, temperature difference, and accessories mass ratio. The results suggest that the optimized liquid-cooling system achieves high cooling efficiency and is lightweight compared with other liquid-cooling systems. The maximum temperature can be controlled below 36 °C, while the temperature difference is limited to 0.65 °C at a 3-C discharge rate. Besides, the accessories mass ratio of the battery module is declined to 10.25%.
7 July 2021 in IEEE Transactions on Transportation Electrification
Temperature inconsistency is inevitable during the battery operation, which has a significant impact on its performance. To quickly predict the temperature distribution in a battery cell, a three-heat-source electro-thermal coupled model is proposed in this article. The temperature of four feature regions in a battery cell can be determined in short time, which is potential to be implemented online. In addition, the distributed equivalent circuit model is proposed to calculate the heat generated by different heat sources. To identify the parameters of the electrical and thermal submodels, the experimental test bench is established, and the parameterizations under different conditions are carried out. In addition, the transient parameters, including the internal resistance and entropy coefficient, are adjusted with different state of charges (SOCs) and temperature. Finally, the validity and robustness of the proposed model are demonstrated through various tests of different operating conditions. The results illustrate that the uneven surface temperature distribution of the battery cell can be estimated fast, in less than 1 s. The error deviation of the proposed model is less than 1.4 °C under different conditions.