We present the simulation results of a Ku-band overmoded Cerenkov type high power microwave oscillator. A guiding magnetic field as low as 0.6 T has been operated in the device. Overmoded slow wave structures with gradually tapered vanes are used in order to increase power capacity and the efficiency of beam-wave interaction. The drift cavity is adopted to enhance the beam-wave interaction of the device. After numerical optimization, the designed generator with an output microwave power of 1.2 GW, a frequency of 13.8 GHz, and a power conversion efficiency as high as 38% can be achieved, when the diode voltage and current are, respectively, 540 kV and 5.8 kA. The power compositions of TM0n modes of the output microwave have been analyzed, the results of which show that TM01 mode takes over almost 95% of the power proportion.
Particle simulation and experimental results are presented about a Ka-band overmoded Cherenkov-type high power millimeter wave generator in this paper. The relativistic electron beam with peak current of 8.4 kA was generated by a pulsed power accelerator working at the voltage of 625 kV, which was guided by an axial magnetic field of 1.05 T and transported through the beam-wave interaction structures. After careful calibration, the microwave power radiated in the far field was as high as about 500 MW, with a frequency of 32.1 GHz and a pulse width of 20 ns. The radiation mode was well controlled to be TM0n mode.
In this paper, a modified numerical method is used to investigate the mode composition of a Gigawatt-class Ka-band overmoded Cerenkov oscillator, which has been proposed and studied in our previous experiment. In the experiment, the measured angular distribution of radiation did not fit a single TM01 mode. So the particle in cell code calculations and the antenna radiation calculations are carried out, which show a consistent picture: the dominant modes are the TM01 mode and the TM03 mode, and their phase relationship is constant with time; therefore, a steady radiation pattern is produced, which matches the experimental data. As a conclusion, the comprehensive analysis shows that the existing modes of the output microwave in our experiment are the first five TM0n modes (n = 1–5), with corresponding power ratios of 36.64%, 0.78%, 56.26%, 5.70%, and 0.52%, and relative phase differences of 0°, 146°, 54°, 169°, and 133°.
When the wavelength of overmoded Cherenkov oscillator goes into Ka-band, power handling capacity becomes an essential issue. Using the TM02 mode or higher order TM0n modes as the operating mode is a potential solution. This paper is aimed to find some proper parameters to make the temporal growth rate of the TM02 mode higher in our previously studied Gigawatt (GW)-class Ka band oscillator. An accurate and fast calculation method of the “hot” dispersion equation is derived for rectangular corrugated SWSs, which are widely used in the high frequency Cherenkov devices. Then, factors that affect the temporal growth rate of the high order TM0n modes are analyzed, including the depth of corrugation, the radius of drift tube, and the diode voltage. Results show that, when parameters are chosen properly, the temporal growth rate of the TM02 mode can be as high as 0.3 ns−1.