13 January 2022 in IEEE Transactions on Microwave Theory and Techniques
A novel millimeter-Wave (mm-Wave) joint radar and communication (JRC) system based on photonic spectrum-spreading phase-coding is proposed. The key to the proposed system is the convergence of photonic microwave phase-coding and spectrum-spreading multiplexing techniques. Phase-coding enables the generation of wideband mm-Wave JRC signal, leading to both high range resolution (< 3.5 cm) for radar detection and high capacity (>1 Gb/s) for wireless communication. The spectrum-spreading multiplexing orthogonalizes the radar signal and communication data, highly reducing mutual interferences. In addition, the spectrum-spreading multiplexing is able to improve both peak sidelobe ratio (PSR) for radar and anti-jamming/anti-noise performance for communication. In the proof-of-concept experiments, a JRC phase-coding signal at 35 GHz is generated. For a 5-Gb/s coding rate, the signal-to-noise ratio (SNR) margin is improved by around 13.8 dB for wireless communication below the pre-forward error correction (FEC) limit, while the PSR reaches ~12 dB for radar. Moreover, the impact of spreading gain on the communication capacity has been discussed, revealing that an optimized spreading gain should be set to balance the radar and communication performances.
4 October 2019 in Journal of Lightwave Technology
A photonic method to estimate the angle-of-arrival (AOA) of microwave signals based on optical phase scanning is proposed and experimentally demonstrated. At remote antenna unit (RAU), one received high-frequency microwave signal is directly applied to a phase modulator (PM), and another received high-frequency microwave signal coupled with a low-frequency large-voltage sawtooth-wave signal is applied to another PM. The sawtooth-wave signal is used to scan the phase of the optical sideband from 0 to 2π. After transmission over a segment of fiber link, the AOA parameter can be estimated by processing the received low-frequency electrical signals at central office (CO). Such scheme can be applicable to either single-tone or wideband microwave signals. Experimental results show that the AOA measurement errors are less than 2.27° and 4.45° for a single-tone signal at 10 GHz and a 2-GHz broadband signal with the center frequency of 18 GHz, respectively.
11 July 2012 in IEEE Photonics Technology Letters
An all-fiber approach to generate phase-coded microwave signals, based on spectral shaping and a frequency-to-time conversion, is proposed and experimentally demonstrated. A phase modulator cascaded by a filter module that has a sinusoidal spectral response is used to create a frequency-shifted optical spectrum. Microwave pulses with the same shape as the optical spectrum are obtained through frequency-to-time conversion in a dispersive fiber. The phase of the generated radio frequency signals can be continuously shifted by tuning the applied voltage on the optical phase modulator.
2 August 2013 in IEEE Photonics Technology Letters
We employ coherent detection and digital signal processing (DSP) to characterize the dynamic evolution of channel matrix in two-mode fibers (TMFs). We develop novel DSP algorithms to compute channel evolution frequency. We measure a few different fiber spools in the lab and find that the evolution frequency of TMF channel matrix can reach as fast as 25 kHz, and the channel of TMF evolves faster than that of single mode fiber.
27 April 2018 in Journal of Lightwave Technology
A stable downlink transmission scheme for wideband anonymous microwave signals in distributed noncooperative system has been proposed and experimentally demonstrated based on an optical switch (OS) scanning. With the round-trip transmission of a pilot carrier, the delay variation of fiber induced by environment is obtained continuously, and can be canceled by controlling variable optical delay line. Furthermore, assisted by an OS, four stable optical downlinks can be realized by employing only one phase drift correction unit, leading to the significant reduction of the system cost increment. Experimental results show that target signals at frequencies of 2 and 18 GHz have been downlink transferred from four different remote ends with the phase fluctuation of only 3.6° and 8.4° at 2 hours through 0.5-km fiber. In addition, the stable phase value for channel can be adjusted from −150° to 150° individually.
18 October 2012 in Journal of Lightwave Technology
Few-mode fiber (FMF) compatible optical add/drop multiplexer (OADM) is indispensable for the future flexible high-speed mode-division multiplexed (MDM) optical networks. In this paper, we demonstrate a proof of concept of FMF compatible OADM which enables add/drop functionality for MDM superchannels. The OADM consists of two cascaded free-space thin-film filters with 5° incident angle. We demonstrate the rerouting of 3 × 318 Gb/s MDM CO-OFDM superchannels via the proposed OADM. The experimental results show 2.6, 2.4, and 0.7 dB OSNR penalties for add, drop, and through ports, respectively. Additionally, we demonstrate a heterodyne receiver configuration which can handle multiband detection without incurring penalty of spectral efficiency.