Ruchun Wu

Ruchun Wu

Auto-generated profile, based on publicly available information

Ruchun Wu

Forest Products Laboratory, U.S. Department of Agriculture Forest Service, Madison, WI 53726, USA

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2017 in Science Advances
Verified
Journal Article
Open access
PDF file
Liheng ChenLiheng Chen
Liheng Chen
JDJinze Dou
Jinze Dou
QMQianli Ma
Qianli Ma
NLNing Li
Ning Li
RWRuchun Wu
Ruchun Wu
JZJunyong Zhu
Junyong Zhu
We report the discovery of the hydrotropic properties of a recyclable aromatic acid, p-toluenesulfonic acid (p-TsOH), for potentially low-cost and efficient fractionation of wood through rapid and near-complete dissolution of lignin. Approximately 90% of poplar wood (NE222) lignin can be dissolved at 80°C in 20 min. Equivalent delignification using known hydrotropes, such as aromatic salts, can be achieved only at 150°C or higher for more than 10 hours or at 150°C for 2 hours with alkaline pulping. p-TsOH fractionated wood into two fractions: (i) a primarily cellulose-rich water-insoluble solid fraction that can be used for the production of high-value building blocks, such as dissolving pulp fibers, lignocellulosic nanomaterials, and/or sugars through subsequent enzymatic hydrolysis; and (ii) a spent acid liquor stream containing mainly dissolved lignin that can be easily precipitated as lignin nanoparticles by diluting the spent acid liquor to below the minimal hydrotrope concentration. Our nuclear magnetic resonance analyses of the dissolved lignin revealed that p-TsOH can depolymerize lignin via ether bond cleavage and can separate carbohydrate-free lignin from the wood. p-TsOH has a relatively low water solubility, which can facilitate efficient recovery using commercially proven crystallization technology by cooling the concentrated spent acid solution to ambient temperatures to achieve environmental sustainability through recycling of p-TsOH.

19 March 2025 in Process Safety and Environmental Protection
Verified
Journal Article
Closed access
JJJiarong Jin
Jiarong Jin
XLXuliang Lin
Xuliang Lin
CTChak-yin Tang
Chak-yin Tang
WLWing Cheung Law
Wing Cheung Law
RWRuchun Wu
Ruchun Wu
LZLei Zhong
Lei Zhong

18 March 2011 in Preparative Biochemistry & Biotechnology
Verified
Journal Article
Closed access
RLRihui Lin
Rihui Lin
RWRuchun Wu
Ruchun Wu
Xin-Lin HuangXin-Lin Huang
Xin-Lin Huang
TXTao Xie
Tao Xie
Oxalate decarboxylase, an oxalate degradation enzyme used for medical diagnosis and decreasing the oxalate level in the food or paper industry, was covalently immobilized to Eupergit C. Different immobilization parameters, including ratio of enzyme to support, ammonia sulfate concentration, pH, and incubation time, were optimized. Under the condition of enzyme/support ratio at 1:20, pH 9, with 1.5 mol/L (NH4)2SO4, room temperature, and shaking at 30 rpm for 24 hr, activity recovery of immobilized Oxdc reached 90% with an apparent specific activity of 0.44 U/mg support. The enzymatic properties of immobilized Oxdc were investigated and compared with those of the soluble enzyme. Both shared a similar profile of optimum conditions; the optimum pH and temperature for soluble and immobilized Oxdc were 3.5 and 50°C, respectively. The immobilized enzyme was more stable at lower pH and higher temperatures. The kinetic parameters for soluble and immobilized enzyme were also determined.