1 March 2009 in Journal of Fluorine Chemistry
31 August 2020 in Wood Research
17 May 2022 in Monatshefte für Chemie - Chemical Monthly
1 October 2019 in Acta Chimica Slovaca
Pretreatment of particles obtained from lignocellulosic materials by steam explosion with indirect control by enzymatic hydrolysis has been studied. The dendromass pretreatment model has been applied for recycled fibreboard and particle board based on softwood. Their structure and chemical composition partly predetermine these lignocellulosic materials consisting of a mixture of spruce and fir particles also for bioethanol production. Optimum steam explosion temperature of 205 °C was determined based on the concentration of total monosaccharides — glucose, xylose and arabinose, among all experimentally prepared hydrolysates. This corresponds to basic conditions for fine disintegration of biomass to lignocellulosic structure with good holocellulose accessibility. Particles obtained from fibreboard and particle board primarily consisting of softwood without steam explosion pretreatment provide relatively low cellulose accessibility for commercial enzymes activity while monosaccharides concentration is partly reduced because of torrefaction at high temperatures. The concentration of monosaccharides in hydrolysates was determined for original sample and each steam explosion temperature. Based on the steam explosion conditions, the effect of severity factors was investigated to find optimum pretreatment conditions to increase accessibility of softwood cellulose and hemicelluloses. The identified optimum severity factor
R
O
= 4.09 matches the optimum steam explosion temperature of 205 °C and the residence time of 10 minutes.
24 August 2022 in Nova Biotechnologica et Chimica
Waste dendromass is one of the least used types of biomass and together with waste from the harvesting and processing of agricultural crops, belongs to the wastes that have a high potential for the second-generation ethanol production. Mass concentration of biofuel added to fossil fuels is established by law and this concentration is determined within the reference values for each year. For example, for 2021 it was 8.0 % and for years from 2022 to 2030 the value will increase to 8.2 %. Biofuels in the so-called reference value in the total fuel content have been mandatory since 2017, while the specific reference value is calculated from the energy content of the total amount of fuels placed on the market. This paper provides initial considerations and pilot results based on experimental data obtained in our workplace concerning the application potential of selected type of dendromass – beech particles from the point of view of their pretreatment by steam explosion and steam extrusion for potential production of liquid biofuels based on lignocellulosic biomass. We compared temperature courses of the mentioned pretreatment methods and pretreated samples were tested by enzymatic hydrolysis. Enzymatic hydrolysis results showed that steam explosion and steam extrusion led to concentration enhancement of fermentable monosaccharides compared to original samples depending on used pretreatment method.
31 August 2021 in Wood Research
The publication is focused on the effect of ultra low and high temperature on enzymatic pretreatment of beech wood (Fagus sylvaticaL.). Two fractions < 0.7 mm and 1.0 –2.5 mm of disintegrated branches sawdust were used for experiments. Glucose and xylose yields were measured after 24, 48, and 72 hours of enzymatic hydrolysis with 15 % load of the enzyme measured to total cellulose content. The influence of freezing under -80°C and boiling under pressure at +160°C on samples before enzymatic hydrolysis was observed. Mutual combination of boiling under pressure to obtain the maximum water uptake and subsequent freezing was used to better understand the process of cell destruction. The results show that the boiling pretreatment has a positive influence on thetotal monosaccharide yields and the subsequent freezing may slightly increase these yields even further. The maximum monosaccharide conversion (73.24%) was achieved using the fraction < 0.7 mm.