30 November 2022 in ACS Earth and Space Chemistry
31 July 2018 in RSC Advances
Coal mine gas (CMG) is a form of unconventional natural gas and its reserves are abundant. However, a large proportion of coal mine gas cannot be used owing to the low concentration of the extraction gas. The hydrate-based method can be used for the separation and recovery of methane from coal mine gas. To devise an economic and efficient method for the separation of mine gas using hydrates, dry water (DW) was used as the carrier for separation under conditions in which the initial pressure was fixed at 10 MPa and the temperature was set at 274 K. On this basis, repeated gas hydrate separation experiments were carried out three times. A pure-water system, a stirring system, and a system using a compound solution of 1 mol L−1 THF + 500 mg L−1 SDS were used in control experiments. The spectral characteristics of the gas hydrates in pure water were determined by Raman spectroscopy, and the hydration index was calculated. The concentrations of gas components in the equilibrium gas phase were determined by chromatography. Moreover, the hydrate formation rate, methane recovery rate, distribution coefficient and separation factor were also calculated. The results indicate that the average gas hydrate formation rate was up to 6.85 × 10−4 mol min−1 in the presence of the THF + SDS solution. The maximum average methane recovery rate was 38.15%, the average distribution coefficient was up to 1.99, the average separation factor reached 2.47 and the highest methane concentration in the hydrate phase was 32.2% in DW. In the experimental range, the efficiency of DW in the recovery of methane by gas hydrate separation was greater than that of the stirring system and the system using the THF + SDS compound solution.
20 May 2022 in Frontiers in Materials
As a critical technical issue, gas extraction borehole sealing significantly restricts the effects of gas extraction. Polymer-modified cement-based composite (PMCC) sealing materials were developed to improve the sealing effect of gas extraction drilling. In this study, a self-built mechanical property and permeability test platform for grouting-based cemented coal bodies was used to test the viscosity, gelation time, and mechanical properties of PMCC sealing materials and the permeability of cemented coal bodies. Through the obtained relevant results, it was demonstrated that the material viscosity of PMCC sealing materials and the permeability and compressive strength of cemented bodies are under the influence of additive ratios. Moreover, the viscosity of sealing materials was found to be linearly related to the gelation time. In particular, the higher the viscosity, the shorter the gelation time. Additionally, on one hand, it was found that the viscosity of such sealing materials is positively correlated to the compressive strength of cemented coal bodies. On the other hand, it forms a negative correlation with their permeability. Based on relevant analysis outcomes, it was deemed that the sufficient hydration reaction and the interspace reticulate microstructure formed by the polymer of PMCC sealing materials allow the cemented coal body to achieve high compressive strength and low permeability.
5 November 2025 in International Journal of Mining Science and Technology
29 December 2020 in ACS Omega
In the process of coal mining, gas outburst is a challenge that must be prevented to guarantee mining safety. Forming gas hydrate in coal can reduce the original gas pressure and delay the concentrative outbursts of gas flow, which is one of the potential technologies to prevent gas outbursts in coal. In this work, we perform the formation and dissociation kinetics experiment of hydrate in the presence of coal and tetrahydrofuran (THF) at the temperature based on different geological conditions in China by means of the experimental device with the impedance measurement function. The results showed that the impedance change can qualitatively describe the kinetic characteristics of hydrate formation and dissociation in coal. The sudden change in pressure and system impedance during gas hydrate formation indicated the nucleation point at which hydrate formation started, by which the induction time can be acquired. Pressure and impedance suddenly changed at the same time, which implied that methane molecules and tetrahydrofuran (THF) molecules entered the hydrate phase at the same time. When the dissociation temperature increased to 303.15 K, the hydrate dissociation rate can be less affected by dissociation temperature if it continued to increase. This work highlights that gas hydrate formation in coal can effectively prevent gas outbursts.
2 July 2025 in Energy & Fuels