Abhishek Kumar Singh

Abhishek Kumar Singh

Auto-generated profile, based on publicly available information

Abhishek Kumar Singh

Indian Institute of Technology Ropar

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications


25 March 2020 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
ASAbhishek Kumar Singh
Abhishek Kumar Singh
NCNitesh K. Chourasia
Nitesh K. Chourasia
BPBhola N. Pal
Bhola N. Pal
APA. Pandey
A. Pandey
PCP. Chakrabarti
P. Chakrabarti
UV lamps used for phototherapy for the treatment of several skin diseases do not have uniform output. This makes the treatment difficult and less responsive. A Ultraviolet B (UV-B) sensitive thin-film phototransistor has been fabricated and characterized to monitor the intensity of UV radiation in phototherapy of skin diseases like psoriasis, vitiligo, and atopic dermatitis. Phototherapy with UV-B ranges from 280 to 320 nm, safe and very effective for skin disease treatment. Hence, to make it portable and affordable for medical technologies, we have demonstrated the fabrication process of a low-operational (≤2V), low-cost solution-processed Li₂ZnO₂ (dielectric)/SnO₂ (channel)-based phototransistor that shows very high photosensitivity at around ~300 nm of UV-B region. The working principle depends on the passage of UV-B light through a window followed by striking a micrometer-scale semiconductor phototransistor. The responsivity and external quantum efficiency (EQE) of the fabricated phototransistor was found to be about 0.12 A/W and 40.12% at 300 nm, respectively, at a notably low operating voltage (≤ 2 V). High sensitivity (>200%) with fast response time (7 s) was also achieved with UV-B irradiation of 650 μW/cm². For in-depth performance analysis of the fabricated device, modeling has also been done, and the outcome matched well with the experimental results.

4 December 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
ASAbhishek Kumar Singh
Abhishek Kumar Singh
APAmritanshu Pandey
Amritanshu Pandey
PCP. Chakrabarti
P. Chakrabarti
This article draws attention to monitoring water-based diseases of human beings and other aquatic animals caused by a high level of ammonia present in water. A flexible sensor for measuring the level of ammonia in water or aqueous solution has been fabricated and tested. Most of the conventional sensors are either not stable or suitable for the measurement of underwater ammonia. Because of this, we intend to make a modest attempt to propose a low-cost, foldable, stable, and reliable Copper oxide (CuO) nanowire electrode-based ammonia sensitive extended gate field-effect transistor (EG-FET). In this article, CuO nanowire has been synthesized at low temperatures for realizing an extended gate for field-effect-transistor (FET). The device has been characterized for aqueous ammonia sensing at different levels of concentrations of ammonia. The sensor exhibits very high linearity [> 99%] along with high sensitivity (>65 [mV]/[mg/L] and 1.62 μA1/2 / [mg/L]). The sensor performance has also been studied under the bending condition showing an excellent sensing performance and linearity without any performance degradation. The various characterizations have been done to validate the crystalline, uniform, and dense formation of CuO nanowires using a high-resolution scanning electron microscope (SEM) and tunnel microscope TEM. The device is well suited to measure the NH3 content (from 1.5 mg/L (or ppm) to 7.5 mg/L) in an aqueous solution.

26 August 2020 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
NCNitesh K. Chourasia
Nitesh K. Chourasia
ASAbhishek Kumar Singh
Abhishek Kumar Singh
SRSuyash Rai
Suyash Rai
ASAnand Sharma
Anand Sharma
PCP. Chakrabarti
P. Chakrabarti
BPBhola N. Pal
Bhola N. Pal
Large-area-based field-effect transistor (FET) gas sensor has the potential to provide a larger sensing area for a chemical analyte. So far, graphene FETs (GFETs) are mostly fabricated by expensive lithographic techniques with a minimum channel length. We have demonstrated a simple way to fabricate a very large channel length of 0.45 mm GFET using ion-conducting dielectric with thermally evaporate source/drain electrodes and has been demonstrated for an application of ambient atmosphere ammonia gas sensing. Ion-conducting Li₅AlO₄ gate dielectric has reduced operating voltage up to 2.0 V with good current saturation. The chemical vapor deposition (CVD) grown uniform monolayer of graphene has been used as an active channel layer of FET. The fabricated device has been tested for different concentrations of ammonia in ambient environment conditions at 25 °C temperature, which indicates that the Dirac point voltage of the device varies up to 0.8 V when the concentration of ammonia has been changed from 0 to 3 ppm. Moreover, this study also reveals that this GFET is capable of detecting ammonia up to the concentration level of 0.1 ppm.

24 November 2020 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
ASAbhishek Kumar Singh
Abhishek Kumar Singh
NCNitesh K. Chourasia
Nitesh K. Chourasia
BPBhola Nath Pal
Bhola Nath Pal
APAmritanshu Pandey
Amritanshu Pandey
PCP. Chakrabarti
P. Chakrabarti
This article demonstrates that ZnO can be used both as the insulating dielectric and the channel by appropriately mixing with lithium and indium, respectively. The ion-conducting lithium zinc oxide (Li2ZnO2) as the dielectric and indium zinc oxide (IZO) as the channel used to fabricate thin-film transistors operating in accumulation mode are derived using the solution-processable method. The novelty of the structure is that both dielectric and channel are made up of ZnO, which provide the possibility of least interface trap states with very high capacitive coupling (318 nF/cm2) makes the device more attractive for low power electronics. The fabricated devices exhibit low operational voltage (≤2V) with high carrier mobility. Indium doped-ZnO is a large-bandgap material that can be utilized for narrowband UV-B (310 nm) detection, for narrowband phototherapy to treat certain skin diseases.