17 August 2005 in Environmental Science & Technology
1 January 2006 in Geophysics
Induced polarization (IP) measurements were conducted on saturated kaolinite-, iron-, and magnetite-sand mixtures as a function of varying percentage weight of a mineral constituent: 0%–100% for iron and magnetite and 0%–32% for kaolinite. We determined the specific surface area for each mineral using nitrogen gas adsorption, where the porosity of each mixture was calculated from weight loss after drying. We fit a Cole-Cole model (Cole and Cole, 1941) to the electrical data obtained for the magnetite and iron mixtures. In contrast, the kaolinite mixtures showed a power-law dependence of phase-on frequency. The global polarization magnitude we obtained from the Cole-Cole modeling of the iron and magnetite mixtures displays a single, near-linear dependence on the ratio of surface area to pore volume (Sp) calculated for the mixtures. A similar relationship is found using a local measure of polarization (imaginary conductivity at 1 Hz) for the clay-sand mixtures. The Sp appears to be a critical parameter for determining IP in both metallic- and clay-containing soils. This result is not easily reconciled with traditional models of induced polarization.
10 July 2012 in Water Resources Research
1 December 2016 in Journal of Applied Geophysics
1 January 2018 in Journal of Applied Geophysics
23 October 2020 in Geophysical Journal International
SUMMARY: Soil stabilization processes aim at enhancing soil's engineering properties. Although the concept is straightforward, it involves physical and chemical changes to the subsurface that could result in local environmental changes. Compared to conventional soil stabilization methods (such as cement grouting), bio-mediated soil stabilization, such as microbial-induced calcite precipitation (MICP), offers the opportunity to minimize environmental impact, but the underlying processes need to be well understood for proper applications. Accurate characterization and long-term monitoring are paramount for the success of soil improvement, especially MICP treatments. Spectral induced polarization (SIP), an established geophysical method, has shown to be sensitive to MICP processes and products (e.g. calcite). In this work, we performed a two-phase study to explore SIP's suitability as a monitoring tool. Phase 1 involved a laboratory scale MICP study under controlled conditions and phase 2 a pilot field scale study. In the laboratory, MICP was induced through the introduction of ureolytic microorganisms, while in the field, indigenous soil microbes were stimulated to promote ureolysis. In both cases, traditional geochemical monitoring, along with spatiotemporally dense SIP monitoring, were performed. Over the course of the laboratory study, SIP successfully tracked the MICP progress as well as the calcite precipitation behaviour. Similarly, the SIP results of the field scale study showed to be sensitive to the subsurface changes in response to MICP. SIP offered spatiotemporally rich information on the MICP progress and process status. The similarity between observed signal trends in the laboratory and field in this study clearly proved that SIP signals from MICP in controlled laboratory environments can be successfully used to study field MICP applications despite scale and complexity differences.