19 April 2018 in Nature Communications
Two-dimensional van der Waals materials have demonstrated fascinating optical and electrical characteristics. However, reports on magnetic properties and spintronic applications of van der Waals materials are scarce by comparison. Here, we report anomalous Hall effect measurements on single crystalline metallic Fe3GeTe2 nanoflakes with different thicknesses. These nanoflakes exhibit a single hard magnetic phase with a near square-shaped magnetic loop, large coercivity (up to 550 mT at 2 K), a Curie temperature near 200 K and strong perpendicular magnetic anisotropy. Using criticality analysis, the coupling length between van der Waals atomic layers in Fe3GeTe2 is estimated to be ~5 van der Waals layers. Furthermore, the hard magnetic behaviour of Fe3GeTe2 can be well described by a proposed model. The magnetic properties of Fe3GeTe2 highlight its potential for integration into van der Waals magnetic heterostructures, paving the way for spintronic research and applications based on these devices.
1 January 2011 in Corrosion Science
1 September 1994 in Physical Review B
Raman spectroscopy, cross-sectional transmission electron microscopy, and electron-energy-loss spectroscopy have been used to monitor the ion-beam-induced transformation in glassy carbon irradiated with 320-keV Xe ions to doses between 5× and 6× ions/. It was found that (i) the ion beam amorphizes the glassy carbon structure; (ii) the amorphization is accompanied by a compaction of the glassy carbon from an initial density of 1.55 to 2.2±0.2 g/; and (iii) approximately 15% of the graphitelike bonds in glassy carbon are converted to diamondlike bonds in the amorphization process. The transformation of glassy carbon to an amorphous state occurs in two distinct stages as a function of ion dose. For damage levels up to 0.2 displacements per atom (dpa) the effect of the ion beam is to decrease the average graphitic crystallite size. Above 0.2 dpa, disorder in bond length and bond angle away from ideal graphitic threefold coordination occurs leading to complete amorphization at high doses. The amorphization, compaction, and presence of ≊15% bonds in the implanted layer of glassy carbon results in a surface layer which is significantly more resistant to abrasion than as-grown glassy carbon.
1 January 2010 in Corrosion Science
1 January 2011 in Corrosion Science
26 July 2012 in Nanoscale
AZAhmad Sabirin Zoolfakar
+3
We demonstrate that a three dimensional (3D) crystalline tungsten trioxide (WO3) nanoporous network, directly grown on a transparent conductive oxide (TCO) substrate, is a suitable working electrode material for high performance electrochromic devices. This nanostructure, with achievable thicknesses of up to 2 μm, is prepared at room temperature by the electrochemical anodization of a RF-sputtered tungsten film deposited on a fluoride doped tin oxide (FTO) conductive glass, under low applied anodic voltages and mild chemical dissolution conditions. For the crystalline nanoporous network with thicknesses ranging from 0.6 to 1 μm, impressive coloration efficiencies of up to 141.5 cm2 C−1 are achieved by applying a low coloration voltage of −0.25 V. It is also observed that there is no significant degradation of the electrochromic properties of the porous film after 2000 continuous coloration–bleaching cycles. The remarkable electrochromic characteristics of this crystalline and nanoporous WO3 are mainly ascribed to the combination of a large surface area, facilitating increased intercalation of protons, as well as excellent continuous and directional paths for charge transfer and proton migration in the highly crystalline material.