29 September 2017 in Journal of Fluid Mechanics
Wavepackets obtained as solutions of the flow equations linearised around the mean flow have been shown in recent work to yield good agreement, in terms of amplitude and phase, with those educed from turbulent jets. Compelling agreement has been demonstrated, for the axisymmetric and first helical mode, up to Strouhal numbers close to unity. We here extend the range of validity of wavepacket models to Strouhal number $St=4.0$ and azimuthal wavenumber $m=4$ by comparing solutions of the parabolised stability equations with a well-validated large-eddy simulation of a Mach 0.9 turbulent jet. The results show that the near-nozzle dynamics can be correctly described by the homogeneous linear model, the initial growth rates being accurately predicted for the entire range of frequencies and azimuthal wavenumbers considered. Similarly to the lower-frequency wavepackets reported prior to this work, the high-frequency linear waves deviate from the data downstream of their stabilisation locations, which move progressively upstream as the frequency increases.
25 May 2017 in Journal of Fluid Mechanics
Three methods are considered for estimating the downstream evolution of wavepackets in turbulent jets based on upstream measurements. The parabolised stability equations are used to compute a transfer function between axially and radially separated points in the flow, and the performance of this theoretical model is compared with that of two empirical approaches, direct transfer function calculation and autoregressive moving-average exogenous system identification, both of which require unsteady experimental data. The three approaches, which perform equally well, prove suitable for estimation of the downstream evolution of wavepackets using pressure data measured in the near-nozzle region. Over distances of the order of a couple of jet diameters, correlations of up to 80 % are observed between estimation and measurement. The performance deteriorates as axial separation between input and output is increased. While the two empirical approaches are limited in terms of both the number of input–output pairs and the number of flow variables that can be reasonably considered, the parabolised stability equations-based approach has no such limitation and can be used to perform full-field estimates comprising all of the dependent variables; in this it constitutes a potentially formidable means by which to perform single-input–multiple-output estimation. It has the further advantage of not requiring unsteady data for its construction, the only necessary ingredients being the mean flow and the linearised equations of motion.
11 February 2019 in Journal of Fluid Mechanics
Three methods are evaluated to estimate the streamwise velocity fluctuations of a zero-pressure-gradient turbulent boundary layer of momentum-thickness-based Reynolds number up to $Re_{\unicode[STIX]{x1D703}}\simeq 8200$ , using as input velocity fluctuations at different wall-normal positions. A system identification approach is considered where large-eddy simulation data are used to build single and multiple-input linear and nonlinear transfer functions. Such transfer functions are then treated as convolution kernels and may be used as models for the prediction of the fluctuations. Good agreement between predicted and reference data is observed when the streamwise velocity in the near-wall region is estimated from fluctuations in the outer region. Both the unsteady behaviour of the fluctuations and the spectral content of the data are properly predicted. It is shown that approximately 45 % of the energy in the near-wall peak is linearly correlated with the outer-layer structures, for the reference case $Re_{\unicode[STIX]{x1D703}}=4430$ . These identified transfer functions allow insight into the causality between the different wall-normal locations in a turbulent boundary layer along with an estimation of the tilting angle of the large-scale structures. Differences in accuracy of the methods (single- and multiple-input linear and nonlinear) are assessed by evaluating the coherence of the structures between wall-normally separated positions. It is shown that the large-scale fluctuations are coherent between the outer and inner layers, by means of an interactions which strengthens with increasing Reynolds number, whereas the finer-scale fluctuations are only coherent within the near-wall region. This enables the possibility of considering the wall-shear stress as an input measurement, which would more easily allow the implementation of these methods in experimental applications. A parametric study was also performed by evaluating the effect of the Reynolds number, wall-normal positions and input quantities considered in the model. Since the methods vary in terms of their complexity for implementation, computational expense and accuracy, the technique of choice will depend on the application under consideration. We also assessed the possibility of designing and testing the models at different Reynolds numbers, where it is shown that the prediction of the near-wall peak from wall-shear-stress measurements is practically unaffected even for a one order of magnitude change in the corresponding Reynolds number of the design and test, indicating that the interaction between the near-wall peak fluctuations and the wall is approximately Reynolds-number independent. Furthermore, given the performance of such methods in the prediction of flow features in turbulent boundary layers, they have a good potential for implementation in experiments and realistic flow control applications, where the prediction of the near-wall peak led to correlations above 0.80 when wall-shear stress was used in a multiple-input or nonlinear scheme. Errors of the order of 20 % were also observed in the determination of the near-wall spectral peak, depending on the employed method.
3 December 2021 in Physical Review Fluids
In this work we perform reactive control of stochastic disturbances in forced turbulent jets based on destructive interference. The study is motivated by the success of recent studies in applying this type of control on instability waves in transitional boundary layers and free-shear flows. Linear convective mechanisms in the initial region of turbulent jets are explored in order to perform reactive control, wherein the actuation signal is updated in real time based on sensor measurements performed upstream, resulting in an inverse feedforward approach. The control law is based on empirical transfer functions of the jet response to stochastic forcing and actuation, which are measured experimentally. Since turbulent jets have energy content spread in a number of azimuthal wave numbers, we apply axisymmetric forcing at the nozzle lip in order to be able to perform control using a reduced number of sensors and actuators. The external forcing produces axisymmetric wave packets which possess stochastic phases and amplitudes, akin to turbulent fluctuations found in unforced jets. We demonstrate the successful implementation of real-time reactive control of these disturbances, achieving order-of-magnitude attenuations of associated velocity fluctuations. Control is shown to reduce fluctuation levels over an extensive streamwise range.
7 September 2018 in Theoretical and Computational Fluid Dynamics
28 June 2018 in Theoretical and Computational Fluid Dynamics
This work deals with the feedforward active control of Tollmien–Schlichting instability waves over incompressible 2D and 3D boundary layers. Through an extensive numerical study, two strategies are evaluated; the optimal linear–quadratic–Gaussian (LQG) controller, designed using the Eigensystem realization algorithm, is compared to a wave-cancellation scheme, which is obtained using the direct inversion of frequency-domain transfer functions of the system. For the evaluated cases, it is shown that LQG leads to a similar control law and presents a comparable performance to the simpler, wave-cancellation scheme, indicating that the former acts via a destructive interference of the incoming wavepacket downstream of actuation. The results allow further insight into the physics behind flow control of convectively unstable flows permitting, for instance, the optimization of the transverse position for actuation. Using concepts of linear stability theory and the derived transfer function, a more efficient actuation for flow control is chosen, leading to similar attenuation of Tollmien–Schlichting waves with only about 10% of the actuation power in the baseline case.