7 March 2024 in Geophysical Journal International
We present a kinematic slip model and a simulation of the ensuing tsunami for the 2020 Mw 7.0 Néon Karlovásion (Samos, Eastern Aegean Sea) earthquake, generated from a joint inversion of high-rate GNSS, strong ground motion and InSAR data. From the inversion, we find that the source time function has a total duration of ∼20 s with three peaks at ∼4, 7.5 and 15 s corresponding to the development of three asperities. Most of the slip occurs at the west of the hypocenter and ends at the northwest down-dip edge. The peak slip is ∼3.3 m, and the inverted rake angles indicate predominantly normal faulting motion. Compared with previous studies, these slip patterns have essentially similar asperity location, rupture dimension and anti-correlation with aftershocks. Consistent with our study, most published papers show the source duration of ∼20 s with three episodes of increased moment releases. For the ensuing tsunami, the eight available gauge records indicate that the tsunami waves last ∼18-30 hours depending on location, and the response period of tsunami is ∼10-35 min. The initial waves in the observed records and synthetic simulations show good agreement, which indirectly validates the performance of the inverted slip model. However, the synthetic waveforms struggle to generate long-duration tsunami behavior in simulations. Our tests suggest that the resolution of the bathymetry may be a potential factor affecting the simulated tsunami duration and amplitude. It should be noted that the maximum wave height in the records may occur after the decay of synthetic wave amplitudes. This implies that the inability to model long-duration tsunamis could result in underestimation in future tsunami hazard assessments.
1 August 2018 in Natural Hazards and Earth System Sciences
The southernmost portion of the Ryukyu Trench near the island of Taiwan potentially generates tsunamigenic earthquakes with magnitudes from 7.5 to 8.7 through shallow rupture. The fault model for this potential region dips 10° northward with a rupture length of 120 km and a width of 70 km. An earthquake magnitude of Mw 8.15 is estimated by the fault geometry with an average slip of 8.25 m as a constraint on the earthquake scenario. Heterogeneous slip distributions over the rupture surface are generated by a stochastic slip model, which represents the decaying slip spectrum according to k−2 in the wave number domain. These synthetic slip distributions are consistent with the abovementioned identical seismic conditions. The results from tsunami simulations illustrate that the propagation of tsunami waves and the peak wave heights largely vary in response to the slip distribution. Changes in the wave phase are possible as the waves propagate, even under the same seismic conditions. The tsunami energy path not only follows the bathymetry but also depends on the slip distribution. The probabilistic distributions of the peak tsunami amplitude calculated by 100 different slip patterns from 30 recording stations reveal that the uncertainty decreases with increasing distance from the tsunami source. The highest wave amplitude for 30 recording points is 7.32 m at Hualien for 100 different slips. Compared with the stochastic-slip distributions, the uniform slip distribution will be highly underestimated, especially in the near field. In general, the uniform slip assumption only represents the average phenomenon and will consequently ignore the possibility of tsunami waves. These results indicate that considering the effects of heterogeneous slip distributions is necessary for assessing tsunami hazards to provide additional information about tsunami uncertainties and facilitate a more comprehensive estimation.
25 September 2023 in Seismica
Precise Global Navigation Satellite System (GNSS) time series have greatly advanced tectonic studies, particularly in detecting transient deformation signals like slow slip events (SSEs). However, GNSS position data can be noisy, impacting the accuracy of analyses. Traditional denoising methods often struggle with spatially heterogeneous and evolving networks. This study introduces a novel Graph Neural Network (GNN) approach to denoise GNSS time series, effectively managing network heterogeneity and varying station availability. GNNs are robust against temporal gaps, making them suitable for GNSS data. Applied to daily time series for the Cascadia Region processed by the University of Nevada Reno and Central Washington University, our method reduced common-mode noise by more than 70% and 30% on horizontal components, in the two datasets respectively, significantly enhancing surface displacement measurements and slow slip events (SSE) source property estimation. We compared the GNN approach with three simple stack filtering methods, which performed comparably in many situations but are more sensitive to parameter choices. For all methods, substantial noise reduction removes artifacts that could impact geophysical interpretations. Our findings suggest that GNN-based denoising offers a robust, adaptive solution for heterogeneous GNSS networks, enhancing accuracy in tectonic and volcanic process studies, but stack filtering approaches might still outperform the machine learning technique depending on the application.
23 March 2020 in Natural Hazards and Earth System Sciences
Real-time probabilistic seismic hazard assessment (PSHA) was developed in this study in consideration of its practicability for daily life and the rate of seismic activity with time. Real-time PSHA follows the traditional PSHA framework, but the statistic occurrence rate is substituted by time-dependent seismic source probability. Over the last decade, the pattern informatics (PI) method has been developed as a time-dependent probability model of seismic source. We employed this method as a function of time-dependent seismic source probability, and we selected two major earthquakes in Taiwan as examples to explore real-time PSHA. These are the Meinong earthquake (ML 6.6) of 5 February 2016 and the Hualien earthquake (ML 6.2) of 6 February 2018. The seismic intensity maps produced by the real-time PSHA method facilitated the forecast of the maximum expected seismic intensity for the following 90 d. Compared with real ground motion data from the P-alert network, our seismic intensity forecasting maps showed considerable effectiveness. This result indicated that real-time PSHA is practicable and provides useful information that could be employed in the prevention of earthquake disasters.