1 June 2020 in Plasma Sources Science and Technology
We use numerical simulations to study the dynamics of surface discharges, which are common in high-voltage engineering. We simulate positive streamer discharges that propagate towards a dielectric surface, attach to it, and then propagate over the surface. The simulations are performed in air with a two-dimensional plasma fluid model, in which a flat dielectric is placed between two plate electrodes. Electrostatic attraction is the main mechanism that causes streamers to grow towards the dielectric. Due to the net charge in the streamer head, the dielectric gets polarized, and the electric field between the streamer and the dielectric is increased. Compared to streamers in bulk gas, surface streamers have a smaller radius, a higher electric field, a higher electron density, and higher propagation velocity. A higher applied voltage leads to faster inception and faster propagation of the surface discharge. A higher dielectric permittivity leads to more rapid attachment of the streamer to the surface and a thinner surface streamer. Secondary emission coefficients are shown to play a modest role, which is due to relatively strong photoionization in air. In the simulations, a high electric field is present between the positive streamers and the dielectric surface. We show that the magnitude and decay of this field are affected by the positive ion mobility.
1 September 2021 in Plasma Sources Science and Technology
We compare simulations and experiments of single positive streamer discharges in air at 100 mbar, aiming toward model validation. Experimentally, streamers are generated in a plate–plate geometry with a protruding needle. We are able to capture the complete time evolution of reproducible single-filament streamers with a ns gate-time camera. A 2D axisymmetric drift-diffusion-reaction fluid model is used to simulate streamers under conditions closely matching those of the experiments. Streamer velocities, radii and light emission profiles are compared between model and experiment. Good qualitative agreement is observed between the experimental and simulated optical emission profiles, and for the streamer velocity and radius during the entire evolution. Quantitatively, the simulated streamer velocity is about 20% to 30% lower at the same streamer length, and the simulated radius is about 1 mm (20% to 30%) smaller. The effect of various parameters on the agreement between model and experiment is studied, such as the used transport data, the background ionization level, the photoionization rate, the gas temperature, the voltage rise time and the voltage boundary conditions. An increase in gas temperature due to the 50 Hz experimental repetition frequency could probably account for some of the observed discrepancies.
1 June 2022 in Plasma Sources Science and Technology
In this paper, we address two main topics: steady propagation fields for positive streamers in air and streamer deceleration in fields below the steady propagation field. We generate constant-velocity positive streamers in air with an axisymmetric fluid model, by initially adjusting the applied voltage based on the streamer velocity. After an initial transient, we observe steady propagation for velocities of 3 × 10 4 m s −1 to 1.2 × 10 5 m s −1 , during which streamer properties and the background field do not change. This propagation mode is not fully stable, in the sense that a small change in streamer properties or background field eventually leads to acceleration or deceleration. An important finding is that faster streamers are able to propagate in significantly lower background fields than slower ones, indicating that there is no unique stability field. We relate the streamer radius, velocity, maximal electric field and background electric field to a characteristic time scale for the loss of conductivity. This relation is qualitatively confirmed by studying streamers in N 2 –O 2 mixtures with less oxygen than air. In such mixtures, steady streamers require lower background fields, due to a reduction in the attachment and recombination rates. We also study the deceleration of streamers, which is important to predict how far they can propagate in a low field. Stagnating streamers are simulated by applying a constant applied voltage. We show how the properties of these streamers relate to the steady cases, and present a phenomenological model with fitted coefficients that describes the evolution of the velocity and radius. Finally, we compare the lengths of the stagnated streamers with predictions based on the conventional stability field.
1 September 2022 in Plasma Sources Science and Technology
We study negative streamers in ambient air using a 2D axisymmetric fluid model. Depending on the background electric field, we observe accelerating, steady and fading negative streamers. Fading occurs in low background fields, when negative streamers lose their field enhancement and when their velocities become comparable to their maximal electron drift velocities. Our focus is on the steady propagation mode, during which streamer properties like radius and velocity hardly change. However, this mode is unstable, in the sense that a small change in conditions leads to acceleration or deceleration. We observe steady negative streamers in background fields ranging from 9.19 kV cm −1 to 15.75 kV cm −1 , indicating that there is no unique steady propagation field (or stability field). Another finding is that steady negative streamers are able to keep propagating over tens of centimeters, with only a finite conductive length behind their heads, similar to steady positive streamers. Approximately linear relationships are observed between the optical diameter and properties like the streamer velocity and the streamer head potential. From these linear relations, we obtain rough lower bounds of about 0.27 mm to 0.35 mm for the minimal optical diameter of steady negative streamers. The lowest background field in which a steady negative streamer could be obtained is 9.19 kV cm −1 . In contrast, steady positive streamers have recently been obtained in a background field as low as 4.05 kV cm −1 . We find that the properties of steady negative and positive streamers differ significantly. For example, for steady negative streamers the ratio between streamer velocity and maximal electron drift velocity ranges from about 2 to 4.5, whereas for steady positive streamers this ratio ranges from about 0.05 to 0.26.
1 September 2024 in Plasma Sources Science and Technology
We investigate the propagation of positive streamers in CO2 through 3D particle-in-cell simulations, which are qualitatively compared against experimental results at 50 mbar. The experiments show that CO2 streamers are much more stochastic than air streamers at the same applied voltage, indicating that few electrons are available in front of the streamer head. In the simulations, we include a photoionization model for CO2. The computational results show that even a small amount of photoionization can sustain positive streamer propagation, but this requires a background electric field close to the critical field. When we compare streamers in CO2 and in air at the same applied voltage, the electric field at the streamer head and the electron density in the streamer channel are higher in CO2. We discuss the uncertainties in CO2 photoionization and provide an estimate for the quenching pressure, which is based on the radiative lifetime of emitting states and the collision frequency of the gas. Furthermore, a criterion for self-sustained streamer growth in CO2 is presented and compared against simulation results.
1 May 2024 in Plasma Sources Science and Technology
Positive streamer behaviors under repetitive pulses are predominantly dependent on the availability of free electrons. If surface residual electrons stored from previous discharges could be intentionally released and involved into the next discharge, an alternative control freedom is provided apart from voltage waveform tailoring methods that mainly attract or repel gaseous residual charges. Evolutions of repetitively pulsed surface streamers in compressed (0.2 MPa) air were investigated after low-photon-energy pulsed visible (532 nm) and infrared (1064 nm) laser irradiations. Pulse-sequence and temporally resolved diagnostics were implemented to investigate effects of laser parameters (irradiation moment, wavelength, energy) and gas composition. A 2D surface streamer fluid simulation was performed to qualitatively unveil impacts of localized plasma patches. The surface streamer morphology and emission light are significantly and repeatably affected by the laser irradiation before the streamer inception, while, variations totally disappear without the solid surface. The secondary streamer is prolonged accompanied by a higher flashover probability after the pulsed laser irradiation in compressed air. Intriguingly, influences of the infrared laser persist for tens of microseconds before the next voltage pulse. Residual charge dynamics under the laser irradiation are analyzed, where the additional increase of of low electron bound energy is emphasized. The laser induced surface trapped electron desorption is achieved through the direct or the step-wise process, dependent on the laser energy and the surface trap state distribution.