21 March 2013 in High Energy Density Physics
1 September 2012 in High Energy Density Physics
8 March 2010 in IEEE Transactions on Plasma Science
Two-dimensional (r, z) magnetohydrodynamic simulations with nonlocal thermodynamic equilibrium ionization and radiation transport are used to investigate the K-shell radiation output from doubly nested large-diameter (> 60 mm) stainless-steel arrays fielded on the refurbished Z pulsed-power generator. The effects of the initial density perturbations, wire ablation rate, and current loss near the load on the total power, K-shell power, and K-shell yield are examined. The broad mass distribution produced by wire ablation largely overcomes the deleterious impact on the K-shell power and yield of 2-D instability growth. On the other hand, the possible current losses in the final feed section lead to substantial reductions in K-shell yield. Following a survey of runs, the parameters for the perturbation level, ablation rate, and current loss are chosen to benchmark the simulations against existing 65-mm-diameter radiation data. The model is then used to predict the K-shell properties of larger diameter (70 mm) arrays to be imploded on the Z generator.
31 August 2023 in IEEE Transactions on Plasma Science
We review spectroscopic methods developed for the determination of magnetic fields in high-energy-density (HED) plasmas. In such plasmas, the common Zeeman-splitting magnetic-field diagnostics are often impeded by various broadening mechanisms of the atomic transitions. The methods described, encompassing atomic transitions in the visible and ultraviolet spectral regions, are applied to the study of imploding plasmas (in a Z-pinch configuration) with and without pre-embedded magnetic fields, relativistic-electron focusing diodes, and plasma-opening switches. The measurements of the magnetic field in side-on observations of cylindrical-plasma configurations that are local in the radial direction despite the light integration along the chordal lines of sight are discussed. The evolution of the magnetic-field distributions obtained, together with the measurements of the plasma temperature and density, allows for studying the plasma dynamics, resistivity, and pressure and energy balance. In particular, for the Z-pinch, an intriguing question on the current flow in the imploding plasma was raised due to the observation that the current during stagnation mainly flows at relatively large radii, outside the stagnation region. For the premagnetized plasma implosions, all three components of the magnetic field (azimuthal, axial, and radial) were measured, yielding the evolution of the current flow and the efficiency of the axial field compression, as well as the relation between the geometry of the field and the plasma rotation, found to develop in this configuration. The measurements in the relativistic electron diode are used to quantify the shielding of the magnetic field by the plasmas in the diode. Also described are the experimental and theoretical investigations of a nondiffusive fast penetration of magnetic field into a low-density plasma (in the plasma-opening-switch configuration).
15 February 2022 in Journal of Fluid Mechanics
The Naval Research Laboratory ‘Mag Noh problem’, described in this paper, is a self-similar magnetized implosion flow, which contains a fast magnetohydrodynamic (MHD) outward propagating shock of constant velocity. We generalize the classic Noh (OSTI Tech. Rep. 577058, 1983) problem to include azimuthal and axial magnetic fields as well as rotation. Our family of ideal MHD solutions is five parametric, each solution having its own self-similarity index, gas gamma, magnetization, the ratio of axial to the azimuthal field and rotation. While the classic Noh problem must have a supersonic implosion velocity to create a shock, our solutions have an interesting three-parametric special case with zero initial velocity in which magnetic tension, instead of implosion flow, creates the shock at $t=0+$ . Our self-similar solutions are indeed realized when we solve the initial value MHD problem with the finite volume MHD code Athena. We numerically investigated the stability of these solutions and found both stable and unstable regions in parameter space. Stable solutions can be used to test the accuracy of numerical codes. Unstable solutions have also been widely used to test how codes reproduce linear growth, transition to turbulence and the practically important effects of mixing. Now we offer a family of unstable solutions featuring all three elements relevant to magnetically driven implosions: convergent flow, magnetic field and a shock wave.
28 October 2004 in New Journal of Physics