9 August 2022 in The Journal of Engineering
The quadcopter as one of the UAV (Unmanned aerial vehicles) is inherently unstable, and has six degrees of freedom (6 DOF), while the number of control inputs is four. The present work presents a sequential methodology to analyze and explain the control mechanism of quadcopter‐UAV in academic and research institutions. This methodology includes simulation, modelling, attitude control, Hardware in‐the Loop (HIL) testing methodology, performance evaluation, and an experimental testing platform. Coordinate systems, kinematics, and dynamics systems are derived in great detail. Then, a real‐time test platform is designed to verify system stability in a safe environment. (HIL) simulation was performed by the Pixhawk flight controller board interfaced with the Mission Planner platform. The numerical results include the control parameters of the quadcopter position (phi, theta, psi), and the translation values. The simulation results showed high and reliable performance both at the desired roll, pitch, and yaw angles as well as at the quadcopter position in the coordinate axes. Furthermore, the results of the real‐time experiments (indoor/outdoor flight tests) have successfully demonstrated good stability and high response. Based on the methodology used in this research, the cost and risk of real‐time flight experiments for UAVs have been reduced.
27 July 2019 in Health Sciences Quarterly
PLC is widely used in industrial control application. For this reason, PLC education has an important place in the content of universities and it is explained in different engineering department. In this paper, AC motor speed control by using PLC experimental setup is designed and implemented. Through this experimental setup, students can experience and use of the encoder, 3-phase AC motor and PID control algorithm. Besides, this experimental setup helps students to develop their real time engineering skill and experience in departments of universities such as electrical-electronics, mechatronics, control and automation engineering.
1 June 2022 in Iğdır Üniversitesi Fen Bilimleri Enstitüsü Dergisi
This study presents a low cost, two-channel, on-off type, constant speed myo-electric controlled prosthetic hand project as an educational tool for Biomedical/Control/Mechatronic Engineering. Surface Electromyogram (sEMG) signals were recorded from the muscles of flexor carpi ulnaris and extensor digitorium on the forearm. Signal conditioning of these signals is performed in the analog stages of the system, before passing it on to a microcontroller for further filtering and implementation of control. The control logic is simplified to represent the muscles as being active or inactive, resulting in a very simple on/off control based on the two signals. The on/off control signals are used to drive a myo-electric controlled prosthetic hand-powered by a hobby RC servo motor. A printed circuit board has been designed for the analog stages of the system, and a simple Arduino Microcontroller is used for the digital stages. Other commercial off-the-shelf components were used to keep the cost of the hardware and the software components as low as possible. This project was used as a teaching aid for the final year undergraduate students to demonstrate the use of simple myo-electric signal processing and control techniques.