Brian Holmes

Brian Holmes

Auto-generated profile, based on publicly available information

Brian Holmes

Minnesota Dental Research Center for Biomaterials and Biomechanics, School of Dentistry, University of Minnesota, Minneapolis 55455, USA

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2016 in Dental Materials
Verified
Journal Article
Closed access
JGJiawen Guo
Jiawen Guo
BHBrian Holmes
Brian Holmes
BYBo Yang
Bo Yang
YLYuping Li
Yuping Li
YHYoung Cheul Heo
Young Cheul Heo
AFAlex Fok
Alex Fok

1 April 2020 in Journal of Prosthodontic Research
Verified
Journal Article
Closed access
BYBo Yang
Bo Yang
QHQin Huang
Qin Huang
BHBrian Holmes
Brian Holmes
JGJiawen Guo
Jiawen Guo
YLYuping Li
Yuping Li
AFAlex Fok
Alex Fok
To investigate the effects of different curing modes, including tack cure, on the degree of conversion (DC) and mechanical parameters of dual-cured luting agents for all-ceramic restorations. Immediate light curing, intermittent light curing (2-s tack cure and a 1-min interval before the main cure), delayed light cuing (2-min delay) and chemical or no light curing were used to cure two dual-cured luting agents, RelyX Unicem and PermaCem 2.0, through a 1.5-mm thick lithium disilicate ceramic slide. DC (n=3), micro-hardness (n=5), shrinkage strain (n=4) and shrinkage stress (n=3) were measured under the aforementioned curing modes. The data were analyzed using two-way ANOVA and post-hoc Tukey HSD test, with the level of significance set at α=0.05. For both luting agents, all the light-curing modes produced similar final DC, but using chemical cure only could significantly reduce the DC. The mechanical parameters followed a similar pattern. There were positive but nonlinear correlations between DC and the other mechanical parameters, with the increase in these parameters with DC being slower initially. Provided adequate light curing is applied to a dual-cured luting agent, delaying the light curing or using a tack cure first to facilitate seating of a restoration may not have a significant impact on the luting agent's final degree of conversion. However, using chemical cure only may result in inadequate cure of the luting agent and is recommended only for highly opaque restorations.