Karen Sobnath

Karen Sobnath

Auto-generated profile, based on publicly available information

Karen Sobnath

Université de Paris Cité, CNRS, Laboratoire Matériaux et Phénomènes Quantiques

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2023 in Physical Review X
Verified
Journal Article
Open access
PDF file
MLMathieu Lizée
Mathieu Lizée
AMAlice Marcotte
Alice Marcotte
BCBaptiste Coquinot
Baptiste Coquinot
NKNikita Kavokine
Nikita Kavokine
KSKaren Sobnath
Karen Sobnath
ASAlessandro Siria
Alessandro Siria
Solid-liquid interfaces display a wealth of emerging phenomena at nanometer scales, which are at the root of their technological applications. While the interfacial structure and chemistry have been intensively explored, the potential coupling between liquid flows and the solid’s electronic degrees of freedom has been broadly overlooked up till now. Despite several reports of electronic currents induced by liquids flowing in various carbon nanostructures, the mechanisms at stake remain controversial. Here, we unveil the molecular mechanisms of interfacial liquid-electron coupling by investigating flow-induced current generation at the nanoscale. We use a tuning fork atomic force microscope to deposit and displace a micrometric liquid droplet on a multilayer graphene sample, and observe an electronic current induced by the droplet displacement. The measured current is several orders of magnitude larger than previously reported for water on carbon, and further boosted by the presence of surface wrinkles on the carbon surface. Our results point to a peculiar momentum transfer mechanism between the fluid molecules and graphene charge carriers, mediated mainly by the solid’s phonon excitations. These findings open new avenues for active control of nanoscale liquid flows through the solid walls’ electronic degrees of freedom.

23 March 2023 in Physical Review Applied
Verified
Journal Article
Closed access
PDF file
MRM. Rahimi
M. Rahimi
KSK. Sobnath
K. Sobnath
FMF. Mallet
F. Mallet
PLP. Lafarge
P. Lafarge
CBC. Barraud
C. Barraud
MRM.L. Della Rocca
M.L. Della Rocca
Two-dimensional (2D) materials are attracting an increasing interest in the domain of energy conversion due to their thermoelectric and thermal properties foreseeing increased efficiency. Actual application as thermoelectric materials relies on the ability to fully explore their physical properties once included in real devices, which is a complex task due to the difficulty in managing thermal transport at the nanoscale. Furthermore, 2D materials are extremely sensitive to the environment and device-fabrication contaminants, that can alter their properties with respect to their isolated form. We demonstrate here a complete thermoelectric characterization of devices based on thin flakes (5–6nm) of tungsten diselenide (WSe2) and multilayer graphene (MLGN) deposited on hexagonal boron nitride (h-BN), by coupling electric and thermoelectric measurements with modulated thermoreflectance (MTR). Flake-by-flake MTR scans allow the separate extraction of the anisotropic thermal conductivities of each device’s layer. We find out values for the in-plane k∥ and out-of-plane k⊥ thermal conductivities of kWSe2∥∼24W m−1K−1, kWSe2⊥∼0.13W m−1K−1, kMLGN∥∼1050W m−1K−1, kMLGN⊥∼1W m−1K−1, kh-BN∥∼250−284W m−1K−1, and kh-BN⊥∼1.9−5.5W m−1K−1, which are generally in agreement with the literature. Our work unveils the possibility to perform selective nondestructive measurements of the thermal conductivity of thin flakes of 2D materials embedded in a device configuration, encouraging the use of MTR coupled to electric and thermoelectric characterization to evaluate the overall device thermoelectric performances.

17 June 2024 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
MRM. Rahimi
M. Rahimi
KSK. Sobnath
K. Sobnath
LCL. Chen
L. Chen
FMF. Mallet
F. Mallet
PLP. Lafarge
P. Lafarge
MRM. L. Della Rocca
M. L. Della Rocca
Two-dimensional van der Waals ferroelectric materials play an important role in a wide spectrum of semiconductor technologies and device applications. Integration of ferroelectrics into 2D-layered material-based devices is expected to offer intriguing working principles and add desired functionalities for next-generation electronics. Here, we investigate the electric and thermoelectric properties of thin layers of the 2H and 3R polymorphs of α-In2Se3 embedded in solid-state three-terminal devices. Charge transport measurements reveal a hysteretic behavior that can be ascribed to the effect of ferroelectric polarization at the metal electrode/2D semiconductor interfaces. The thermoelectric investigation of the same devices unveils a well-defined negative signal of the order of 100–200 μV/K in absolute value for the 2H polymorph, showing a slight modulation as a function of the gate voltage. An analogous but noisy thermoelectric voltage is measured for devices based on the 3R polymorph, where indeed a constant finite transversal offset in the 100 μV-few mV range is detected, which does not depend on the applied temperature gradient. We argue that these experimental observations are related to a strong residual in-plane ferroelectric polarization in the 3R α-In2Se3 polymorph thin layer. Our results show that the thermoelectric response is a fine probe of the ferroelectric character of 2D layered α-In2Se3.

6 January 2025 in Applied Physics Letters
Verified
Journal Article
Closed access
VDValerio Digiorgio
Valerio Digiorgio
KSKaren Sobnath
Karen Sobnath
MRMaria Luisa Della Rocca
Maria Luisa Della Rocca
CBClément Barraud
Clément Barraud
RFRémi Federicci
Rémi Federicci
BLBrigitte Leridon
Brigitte Leridon
Over the past few years, ionic conductors have gained a lot of attention because of the possibility of implementing them in various applications such as supercapacitors, batteries or fuel cells, and resistive memories. Especially, layered two-dimensional (2D) crystals, such as h-BN, graphene oxide, and MoSe2, have been shown to provide unique properties originating from the specific 2D confinement of moving ions. Two important parameters are the ion conductivity and the chemical stability over a wide range of operating conditions. In this vein, Rb2Ti2O5 (RTO) has recently been found displaying remarkable properties such as superionic conduction and equivalent colossal dielectric constant. Here, an approach to the study of the electrical properties of the layered RTO 100-nm scale is presented. Characterizations by means of micro-Raman spectroscopy and atomic force microscopy measurements of mechanically exfoliated RTO micro-flakes via the so-called adhesive-tape technique are reported. Finally, the results of electrical measurements performed on an exfoliated RTO micro-flake are presented and are found to be consistent with the results obtained on macroscopic bulk crystals.

2 October 2025 in ACS Applied Electronic Materials
Verified
Journal Article
Open access
KSKaren Sobnath
Karen Sobnath
RBRoberto Bellelli
Roberto Bellelli
MRMehrdad Rahimi
Mehrdad Rahimi
LCLinsai Chen
Linsai Chen
GWGuillaume Wang
Guillaume Wang
FMFrançois Mallet
François Mallet

8 April 2026
Verified
Thesis
Closed access
KSKaren Sobnath
Karen Sobnath
Pompage de spin pur dans des hétérostructures de van der Waals 2D: La spintronique dans les hétérostructures de van der Waals [1] est un domaine de recherche en plein essor offrant des perspectives technologiques vers une électronique post-CMOS ultra-compacte et basse consommation. Les matériaux bidimensionnels (2D) présentent des propriétés essentielles à la spintronique comme une excellente longueur de diffusion de spin [2], un fort couplage spin orbite ou encore le blocage spin-moment [3] qui les placent au coeur des avancées récentes. Plus encore, empilés entre eux, ces hétérostructures peuvent exhiber par effet de proximité des propriétés uniques et même de nouvelles phases de la matière [4]. Les courants de spin jouent un rôle essentiel dans le fonctionnement des dispositifs de spintronique comme les valves de spin basé sur la GMR ou les STT-MRAM, justifiant une activité de recherche intense. Il en résulte 3 concepts clés à maîtriser pour espérer contrôler et exploiter les courants de spin : l'injection, la propagation et la détection. Malgré leur potentiel, l'utilisation des matériaux 2D pour réaliser de tels dispositifs restent limitées par les difficultés de fabrication. Durant ma thèse, j'ai conçu un dispositif unique permettant l'injection d'un courant de spin pur via la méthode de pompage de spin à la résonance ferromagnétique (FMR) et la détection de ce courant par un mécanisme de conversion spin-charge [5]. J'ai travaillé à partir d'un système typique de la spintronique : l'interface FM/NM où le matériau ferromagnétique (FM) est le Cobalt (Co) et le matériau non magnétique (NM) est un matériau de van der Waals bi-dimensionnel i.e. le hBN, le graphène ou le WSe2. J'ai imaginé, simulé puis fabriqué un dispositif intégralement sur puce, adapté aux matériaux 2D qui sont obtenus par exfoliation mécanique et en conséquence limitent la dimension des films de Co au plus à quelques centaines de micromètres carrés. J'ai monté un dispositif expérimental pour réaliser des mesures de FMR large bande (4 à 14 GHz) par une détection synchrone, avec une modulation du champ magnétique, permettant de détecter de faibles volumes magnétiques à température ambiante. J'ai investigué les phénomènes de relaxation de l'aimantation du Co à l'interface avec 3 différents matériaux 2D, quantifiés par le terme d'amortissement de Gilbert extrait de l'ajustement des spectres de FMR. Comme il a été déjà mis en lumière dans la littérature [6] et également par mes résultats expérimentaux, l'augmentation de l'amortissement de l'aimantation ne suffit pas à détecter et quantifier le pompage de spin car il englobe toutes les sources de relaxation magnétiques de mon système. Par ailleurs, en réalisant une étude de la FMR en fonction de l'épaisseur de Co, j'ai pu démontrer la forte contribution de l'effet à deux magnons (TMS) [7] dans l'amortissement de l'aimantation du Co à l'interface avec le hBN ainsi que le graphène. Au contraire, j'ai observé une diminution considérable du terme TMS lorsque le Co est à l'interface avec le WSe2 réduisant la valeur de sa constante d'amortissement de Gilbert à 0.007. Je montre que cela est lié à la réduction de l'anisotropie perpendiculaire de surface du Co. Enfin, j'ai réalisé une détection directe du courant de spin injecté par pompage de spin dans le graphène ou le WSe2 par un mécanisme de conversion spin-charge, mesuré par l'intermédiaire d'un matériau à fort couplage spin orbite tel que le Palladium (Pd) pour l'échantillon de graphène ou directement dans le WSe2. [1] A. K. Geim et I. V. Grigorieva, Nature, vol. 499, p. 419-425 (2013) [2] B. Dlubak et al., Nature Physics, vol. 8, p. 557-561 (2012) [3] S. Manzeli et al., Nature Reviews Materials, vol. 2 (2017) [4] H. Yang et al., Nature Materials (2024) [5] D. Indolese et al., Physical Review Applied, vol. 10, p.044053 (2018) [6] L. Zhu et al., Physical Review Letters, vol. 123, p. 057203 (2019) [7] S. Yoshii et al., Physical Review B, vol. 106, p. 174414 (2022)