Section of Chemical Engineering, Department of Biotechnology, Chemistry and Environmental Engineering, Aalborg University Esbjerg, Niels Bohrs Vej 8, DK-6700 Esbjerg, Denmark
Auto-generated profile, based on publicly available information
Krzysztof P. Kowalski
Section of Chemical Engineering, Department of Biotechnology, Chemistry and Environmental Engineering, Aalborg University Esbjerg, Niels Bohrs Vej 8, DK-6700 Esbjerg, Denmark
Pilot plant investigations of sand and membrane filtration (microfiltration (MF)/ultrafiltration (UF)/nanofiltration (NF)/low pressure reverse osmosis (LPRO)) have been performed to treat groundwater polluted with pesticides. The results show that simple treatment, with use of aeration and sand filtration or MF/UF membranes, does not remove pesticides. However, by reducing the content of key foulants, the techniques can be used as a pre-treatment for nanofiltration and low pressure reverse osmosis that has proved to be capable of removing pesticides. It was found that a lower fouling potential could be obtained by using the membranes, but that sand filter was better at removing manganese and dissolved organic matter. The results indicate that combining aeration, sand filtration and membrane techniques might be a good option for pesticide removal without any addition of chemicals and minimized membrane maintenance.
The results from a new water treatment system for arsenic removal are presented. The technology is based on the employment of an electrolytic iron dissolution and efficient aeration procedure prior to sand filtration. The treatment was introduced and investigated in a pilot scale plant and full scale waterworks. The pilot scale results showed the potential for efficient arsenic removal from spiked solutions (with As in the range of 50–85 μg/L) depending on the process conditions (flow and applied current). In the waterworks where the system was implemented for a period of 14 months, there was a relationship where the higher applied current from the iron generator resulted in a better quality of water produced. The long period of use also helped to determine a proper iron dosage (the Fe/As ratio 68 mg/mg) and identify carbonate scale formation in the electrochemical process. The electrolytic dissolution of the Fe was found to be a practical method for iron dosing; however more work has to be done on process improvement and optimization that will focus on the Fe anode geometry.