Compression After Impact (CAI) strength is critical to the safety and weight of carbon fibre aircraft. In this paper, the standard aerospace industry practice of using separate analyses and tests for panel buckling and CAI strength is challenged. Composite panels with a range of stacking sequences were artificially delaminated and subject to compression testing in a fixture that allowed local sublaminate and global panel buckling modes to interact. Compared to panels without delamination, interaction of buckling modes reduced panel buckling strains by up to 29%. Similarly, compared to delaminated panels restrained against panel buckling, interaction reduced delamination propagation strains by up to 49%. These results are the first to indicate that restriction of interaction during CAI testing is unconservative and therefore potentially unsafe. A novel integration of an analytical Strip model, for sublaminate buckling driven delamination propagation, and a Shanley model, for determining increased local strain due to sublaminate-buckling-induced panel curvature, is used to calculate the reduction in strength due to buckling mode interaction. Assuming a typical sublaminate post to pre-buckling stiffness ratio of 0.65, the difference in integrated model and experimental results is <11% – a level of accuracy that will allow the integrated model to drive initial design studies
This review captures the state-of-the-art carbon fibre-based electrodes and outlines the required research for them to deliver improvements in electrochemical and mechanical performance of structural batteries in future electrified transport.
Leidenfrost water droplets can self-propel on heated surfaces with ratcheted topography, a very useful characteristic for systems with excess heat where fluid flow without moving parts is desirable. Reliability and flow rate are significant concerns for such systems. Here, the effect of the surface profile on reliability and droplet velocity are investigated on a single device with a continuously adjustable millimetre-scale ratcheted surface. Conditions are described under which the droplet velocity can exceed 350 mm/s. The reliability of droplet propulsion is shown to be improved for ratchet geometries with an overhang.