6 March 2006 in IEEE Transactions on Microwave Theory and Techniques
This paper provides a rigorous study of the causes and physical origins of intermodulation distortion (IMD) in RF microelectromechanical systems (MEMS) capacitors, its analytical dependence on the MEMS device design parameters, and its effects in RF systems. It is shown that not only third-order products exist, but also fifth order and higher. The high-order terms are mainly originated by the nonlinear membrane displacement versus applied voltage and, in the case considered in this study, with an additional contribution from the nonlinear dependence of the reflection coefficient phase on the displacement. It is also shown that the displacement nonlinear behavior also contributes to the total mean position of the membrane. In order to study these effects in depth, an analytical frequency-dependent IMD model for RF MEMS based on a mobile membrane is proposed and particularized to the case of a MEMS varactor-a device for which IMD can be significant. The model is validated, up to the fifth order, theoretically (using harmonic balance) and empirically (the IMD of a MEMS varactor is measured). To this end, a two-tone IMD reflection measurement system for MEMS is proposed.
12 November 2012 in IEEE Transactions on Microwave Theory and Techniques
GSGeoffroy Soubercaze-Pun
This paper proposes a method for the experimental estimation of the stability margins in microwave amplifiers. The approach is based on measuring a closed-loop frequency response representing the linearization of the circuit about a steady-state solution. Critical poles of the amplifier are then obtained by applying conventional pole-zero identification techniques to the measured frequency response. As circuit parameters are modified, the evolution of these critical poles on the complex plane provides a practical way to assess the robustness of the design regarding its stability. Two types of common instabilities in microwave amplifiers are studied: low-frequency bias oscillations and parametric oscillations. For the low-frequency oscillations, the approach proposes the inclusion of an observation RF port into the amplifier bias path to experimentally obtain the critical poles of the circuit from a reflection coefficient measurement. Pole-placement techniques are then applied to increase the stability margin of detected critical resonances. For the parametric oscillations, pole-zero identification is applied to a frequency response obtained from a mixer-like characterization equivalent to the measurement of a “hot” reflection coefficient. The methodology is applied to two amplifier prototypes: an L-band field-effect transistor amplifier and a dual-mode WiFi-WIMAX amplifier that exhibit different kinds of unstable behavior.
20 April 2015 in IEEE Transactions on Microwave Theory and Techniques
To reach the video bandwidth requirements on the supply paths, power amplifiers with dynamic bias schemes are constrained to reduce the values of the low-frequency (LF) decoupling capacitors on their bias lines. This can entail a decrease of the LF stability margins, among other negative effects. In this work, a methodology is proposed to experimentally monitor and control the dominant poles that govern the LF dynamics of both gate and drain bias lines from dc to high compression power. A specific topology for the bias observation accesses allows a consistent characterization in large-signal regimes. An automatic procedure to trace root contours versus four control parameters is also developed. The complete approach can be used to optimize the design of the bias lines in terms of video bandwidth, relative stability margins, and bias voltage transfer function characteristics. Moreover, the design can account for the effect of the large-signal RF drive on these LF performances. The methodology is exemplified and validated in a demonstrator prototype specifically built for that purpose.