5 December 2022 in Optics Express
There is little literature characterizing the temperature-dependent thermo-optic coefficient (TOC) for low pressure chemical vapor deposition (LPCVD) silicon nitride or plasma enhanced chemical vapor deposition (PECVD) silicon dioxide at temperatures above 300 K. In this study, we characterize these material TOC’s from approximately 300-460 K, yielding values of (2.51 ± 0.08) · 10−5K−1 for silicon nitride and (5.67 ± 0.53) · 10−6K−1 for silicon oxide at room temperature (300 K). We use a simplified experimental setup and apply an analytical technique to account for thermal expansion during the extraction process. We also show that the waveguide geometry and method used to determine the resonant wavelength have a substantial impact on the precision of our results, a fact which can be used to improve the precision of numerous ring resonator index sensing experiments.
29 October 2020 in Journal of Lightwave Technology
In this work we experimentally demonstrate a fully packaged one-dimensional beam steering system that is based on a fully CMOS compatible silicon photonics platform. This configuration enables multi-wavelength operation and is suitable for short-wavelength infrared (SWIR) applications from light detection and ranging (LIDAR) to telecommunication and sensing applications. The switching fabric in this system employs a 1x9 array of add/drop ring resonators that are fed by a common waveguide through a single etch input grating. The switching fabric re-directs the resonance wavelengths at each drop waveguide to the output facet at the edge of the chip and into free space. The divergent beams that exit the waveguides along the output facet are then collimated and magnified using an array of micro-lenses (pitch = 750 μm, Diameter = 700 μm) in addition to a two lens afocal system in order to enhance the fill factor and diminish any blind zones between adjacent beams. Each one of these drop waveguides is used to address portion of the steering aperture. Combined together they enable steering across the entire aperture. Multi-wavelength operation is obtained by placing individual titanium tungsten alloy (TiW) heaters on top of each ring resonator to enable wavelength tuning.
31 January 2023 in Optics Letters
The design, fabrication, and characterization of a 16-element optical phased array (OPA) using a high index (n = 3.1) silicon-rich silicon nitride (SRN) is demonstrated. We present one-dimensional beam steering with end-fire facet antennas over a wide steering range of >115° at a fixed wavelength of 1525 nm. A beam width of 6.3° has been measured at boresight, consistent with theory. We demonstrate SRN as a viable material choice for chip-scale OPA applications due to its high thermo-optic coefficient, high optical power handling capacity [negligible two-photon absorption (TPA)], wide transparency window, and CMOS compatibility.
27 March 2025 in Optics Express
Waveguide propagation loss and coupling coefficients are key parameters that must be measured routinely following fabrication of integrated photonic chips. While multiple methods exist to measure these parameters, existing methods are either sensitive to off-chip coupling uncertainty and occupy a large footprint (cutback method) or cannot unambiguously distinguish waveguide losses from coupling coefficients (all-pass ring resonator method). In this work, we show that by performing two spectral measurements of an add-drop ring resonator, the waveguide loss and ring-waveguide coupling coefficients can be recovered and unambiguously identified. We perform uncertainty analysis and show that this method recovers waveguide loss and coupling coefficients with lower uncertainty than alternative methods in many situations. Finally, we perform several experimental demonstrations of the technique, highlighting its increased robustness to defects compared to the cutback method and its capability to measure waveguide losses and coupling coefficients on various waveguide platforms. As the add-drop ring resonator used has a relatively small footprint (roughly 200 µm x 100 µm) and unambiguous results can be obtained through measurement of individual resonances, this method represents a convenient tool for integrated photonic process development and fabrication monitoring.