5 November 2025 in Engineering Headway
Renewable energy technologies are considered clean sources of energy and optimal use of these resources minimizes environmental impacts and is sustainable based on current and future economic and societal needs. In Namibia, wind energy can be considered one of the available renewable energy sources. Despite the abundance of wind speed distribution over Namibia, there is a lack of properly analyzed and documented data that could reveal the capabilities of wind energy generation in Namibia. This research aims to assess the wind energy generation potential for Ongwediva and with specific application to the University of Namibia Engineering Campus to determine its suitability. Data for the Jose Eduardo dos Santos (JEDS) Campus was collected from the National Aeronautics and Space Administration (NASA) Data Access Viewer. The collected data was analyzed and modelled using the Weibull probability distribution function. Results from the model predict the wind speed distribution pattern and energy density which constitute the decision variables for the suitability of wind energy application at the selected site. The yearly averaged wind speeds for the study location varied between 3.456 and 3.698 m/s while the calculated yearly averaged wind power density ranged between 22 - 27 W/m 2 for a single turbine. The study concluded that the appropriate wind turbine for the range of wind speed and power density for Ongwediva was the Vestas V100 which could produce 1800 kW of electrical power which may provide CO 2 savings of 4,974 tons/year. This assessment provides data for advancing wind resource development and application in the Engineering campus or around Ongwediva town.
27 June 2018 in EPH - International Journal of Science And Engineering
In this paper, a one dimensional model was developed for the analytical evaluation of the thermal performance of adelugeable flat tube bundle to be incorporated in the second stage of an induced draft hybrid (dry/wet) dephlegmator (HDWD) of a direct air-cooled steam condenser (ACSC). A one-dimensional model is analysed by using three methods of analysis which are: Poppe, Merkel, and heat and mass transfer analogy. The model’s accuracy was validated through a comparison of solutions obtained from the above-mentioned methods of analysis. Satisfactory correlations between theresults were reached. However, heat transfer rate attained by Poppe method is higher by 2.89% and 9.87% than thatobtained by Merkel, and heat and mass analogy methods, respectively. The difference in air-side pressure drop obtainedby all the methods found to be insignificant. Furthermore, the best configuration of the flat tube bundle for the secondstage of induced draft HDWD was identified through the comparison of its performance to the round tube bundle. Theperformance of the round tube bundle is found to be around 2 and 1.5 times of that of flat tube bundle, when both bundles operate in wet and dry operating modes respectively.
5 November 2025 in Engineering Headway
Pilot injection is a useful technique for lowering high rates of pressure rise at injection initiation and ignition delay. This leads to increased hydrocarbon emissions but less nitrogen oxides and noise. This work considers the impact of pilot injection on a twin-cylinder turbocharged common rail direct injection diesel engine powered by diesel. By adjusting the pilot injection quantity from 5 to 25% (in increments of 5%) of the main injection quantity and the pilot injection timing from 0 to 25 crank angle degrees (CAD) in steps of 5 CAD before the main injection, engine experiments were conducted at a constant speed of 2500 rpm and fuel injection pressure of 120 MPa. Performance factors like brake thermal efficiency and brake specific fuel consumption (BSFC), and emission factors like soot and nitrogen oxides were assessed experimentally. The findings show that while BSFC and soot decreased with a rise in pilot injection quantity, BTE and NOx increased. Prior to the main injection, at a pilot injection timing of 10 CAD, improved BTE and BSFC were noted. In relation to pilot injection timing, NOx and soot emissions exhibit opposing tendencies. While soot emissions initially decline until a pilot injection timing of 15 CAD, and then rise, NOx emissions first rise until a pilot injection timing of 15 CAD and then fall.