7 December 2004 in Physical Review Special Topics - Accelerators and Beams
The linear coupling's parameterization in the uncoupled action-angle frame is introduced, where the two eigenmodes' phases at one point and the phase advances between two points in the ring are well defined. The general expressions of the coordinates are also given. The transfer matrix from the action-angle frame to the laboratory frame can be obtained from the eigenvectors of the one-turn transfer map or from Twiss and coupling parameters defined in Edwards-Teng parameterization. Matrix can also be constructed from turn-by-turn beam position monitor (BPM) data. The phase ellipses and beam sizes in different projection planes are calculated through the action-angle parameterization. The two eigenmodes' Twiss and coupling parameters at point are described in terms of the section transfer map and parameters at point . The linear coupling's action-angle parameterization is useful for the analytical calculations and turn-by-turn BPM data interpretations.
18 May 2012 in Physical Review Special Topics - Accelerators and Beams
To compensate the beam-beam tune spread and beam-beam resonance driving terms in the polarized proton operation in the Relativistic Heavy Ion Collider (RHIC), we will introduce a low energy DC electron beam into each ring to collide head-on with the opposing proton beam. The device to provide the electron beam is called an electron lens. In this article, using a 6D weak-strong beam-beam interaction simulation model, we will investigate the effects of head-on beam-beam compensation with electron lenses on the proton beam dynamics for the RHIC 250 GeV polarized proton operation. Frequency maps, dynamic apertures, and proton beam loss rates are calculated for this study. Key beam parameters involved in this scheme are varied to search for the optimum compensation condition. The sensitivities of head-on beam-beam compensation to beam imperfections and beam offsets are also studied.
11 January 2005 in Physical Review Special Topics - Accelerators and Beams
Measurement of the residual betatron coupling with skew quadrupole modulation is a new diagnostics technique. It was developed and tested at the Relativistic Heavy Ion Collider (RHIC) as a promising method for measuring coupling on the ramp. By modulating the strengths of skew quadrupole families, the two tunes' responses are precisely measured with the phase lock loop system. The projection ratio of the residual coupling coefficient onto the coupling modulation direction can be determined. In this article, the analytical solution to the skew quadrupole modulation is given. Dedicated beam studies were carried out in RHIC Run'04 and the results are presented. The ability to measure coupling on the ramp opens the possibility of continuously correcting coupling during acceleration.
4 February 2016 in Physical Review Accelerators and Beams
The Relativistic Heavy Ion Collider (RHIC) at Brookhaven National Laboratory has been operating since 2000. Over the past decade, thanks to the continuously increased bunch intensity and reduced at the interaction points, the peak luminosity in the polarized proton operation has been increased by more than two orders of magnitude. In this article, we will present the operational observations at the routine proton physics stores. The mechanisms for the beam loss, transverse emittance growth, and bunch lengthening are analyzed. Numerical calculations and multiparticle tracking are used to model these observations.
14 December 2006 in Physical Review Special Topics - Accelerators and Beams
We present a new technique to continuously measure and compensate the global difference coupling coefficient through the continuous measurements of eigenmode projection parameters, using a high resolution phase-locked-loop tune meter. First, four eigenmode projection parameters are defined as the observables for weak difference coupling. Then, their analytical expressions are obtained using the strict matrix treatment and the Hamiltonian perturbation theory of linear coupling. From these parameters, the complex global coupling coefficient can be fully determined and compensated. This method was successfully demonstrated in the Relativistic Heavy Ion Collider (RHIC) 2006 run.
13 May 2024 in Physical Review Letters
The Electron-Ion Collider (EIC), to be constructed at Brookhaven National Laboratory, will collide polarized high-energy electron beams with hadron beams, achieving luminosities of up to in the center-of-mass energy range of 20–140 GeV. To achieve such high luminosity, the EIC will employ small and flat beams at the interaction point. In the hadron storage ring of the EIC, the ratio of horizontal to vertical emittances is approximately . In contrast, in previous or existing hadron colliders, the horizontal and vertical emittances are typically similar or closely matched. At the Relativistic Heavy Ion Collider (RHIC), we experimentally demonstrated a large transverse emittance ratio of with gold ion beams at a particle energy of 100 GeV per nucleon, thanks to stochastic cooling and fine decoupling. Furthermore, we demonstrated collisions with flat beams, featuring a transverse beam size ratio of for the first time at the RHIC.