This paper will present the regenerative braking quantification, design control, and simulation of a hybrid energy storage system (HESS) for an electric vehicle (EV) in extreme conditions. The EV is driven by two 30-kW permanent magnet synchronous motors. The HESS contains a Li-Ion battery and ultracapacitor (UC) storage element sources as well as a dissipative resistor. The UC will be mainly involved in braking and traction modes. The role of the resistor is to protect the dc bus and the battery according to the voltage and current constraints. The sizing of the elements takes into consideration the extreme braking conditions of the vehicle while respecting the Economic Commission for Europe Regulation No. 13 Harmonized. Controllers are being used in order to regulate the various electrical variables of the overall system. A sequential logic controller is also being introduced. The role of the sequential logic controller is to activate the different existing regulation controllers and to ensure the switching between the storage elements depending on the system states. Simulation tests will be performed covering a wide operation range for variable braking load, according to vehicle speed and road type, and extreme braking conditions.
In this paper, we will represent the optimal traction and regenerative braking current synthesis for an IPMSM using three combined torque control methods for an Electric Vehicle (EV) using Matlab/Simulink ® . In order to impose torque at higher speed, the flux should be weakened by injecting negative current in the d- axis. Several methods of reference current generation will be described according to the operating speed, torque reference, voltage and current constraints. The torque/speed characteristics will be decomposed into five zones of operation delimited by three methods of control: Maximum Torque per Ampere, Voltage Current Limited Maximum Torque and Constant Power Region.
This article proposes an energy recuperation management of a Hybrid Energy Storage System (HESS) during regenerative braking of an Electric Vehicle. The HESS is composed of a Li-Ion battery, and a high speed Flywheel Energy Storage (FES). At low speed, the integration of a controlled dissipative resistor is used to prevent battery overcurrent and overvoltage. At high speed, Voltage Current Limited Maximum Torque (VCLMT) control method is applied to reach the maximal speed allowed. Sizing of the flywheel and the design of the Permanent magnet synchronous motor (PMSM) control will also be presented. Simulation results show the dynamic behavior of the flywheel according to the PMSM desired control as well as the energy recovery strategy.