27 February 2020 in Applied Optics
The dependence of an emission wavelength on the crystal temperature was first investigated for a diode-pumped continuous-wave -doped (Yb:CALGO) laser. A maximum output power of 11 W was obtained, corresponding to a slope efficiency of 19.8%. The output wavelength varied from 1051.10 nm to 1054.72 nm with increased absorbed pump power. This wavelength shift is attributed to a change in the crystal temperature. This observation is, to our best knowledge, an original conclusion about this phenomenon in a Yb:CALGO laser. We use a temperature-dependent model to explain the emission wavelength shifts that can be generalized to any such quasi-three-level materials.
13 September 2021 in Frontiers in Materials
Graphene/MoS2/Ag thin films were successfully prepared by the magnetron sputtering technique and liquid phase exfoliation. Structure, morphology, optical properties, and nonlinear optical characteristics of the graphene/MoS2/Ag and graphene/MoS2 thin films were studied by X-ray diffractometer, spectrophotometer, field-scanning electron microscope, and femtosecond (fs) Z-scan technique. The results of the fs Z-scan experiment indicate that the graphene/MoS2/Ag thin films exhibit reverse saturable absorption properties due to the free carrier absorption and two-photon absorption. More importantly, with the increase of DC magnetron sputtering power (from 5 to 15 W), the local surface plasmon resonance effect of the Ag thin films increases, which leads to the enhancement of nonlinear optical properties of the graphene/MoS2/Ag thin films. The nonlinear absorption coefficients of the graphene/MoS2/Ag thin films are increased from 1.14 × 10–10 to 1.8 × 10–10 m/W at 800 nm and from 4.79 × 10–11 to 6.79 × 10–11 m/W at 1,030 nm, and the nonlinear refraction index of the graphene/MoS2/Ag thin films is -4.37 × 10–17∼−4.18 × 10–16 m2/W under the excitation of 800 and 1,030 nm, respectively. Moreover, when the graphene/MoS2/Ag thin films were excited at 800 and 1,030 nm, respectively, the nonlinear figure of merit values of the graphene/MoS2/Ag thin films are increased from 1.23 to 2.91 and from 1.30 to 1.47, which are enough to support the application of the graphene/MoS2/Ag thin films in the field of all-optical switching applications.
17 May 2021 in IEEE Photonics Journal
We present an numerical and experimental analysis of a Yb:YAG thin disk regenerative amplifier. Group velocity dispersion, third order dispersion, and self-phase modulation (SPM) effects are considered in the simulations of the amplification process. By virtue of the simulations, a compact femtosecond Yb:YAG thin-disk chirped-pulse regenerative amplifier delivering an average power of 50 W at a central wavelength of 1030 nm with a propagation factor of M 2 <; 1.4 at a repetition rate of 200 kHz and a pulse duration of 500 fs was constructed. Numerical simulation based on this Yb:YAG thin-disk was carried out to investigate the pulse parameters evolution in each round trip. The measured experimental results in pulse width, spectrum, and pulse energy together fitted quite well with the numerical simulation. This plays an important role in the design of high-peak-power regenerative amplifier and will facilitate further power scaling and suppression of gain narrowing of the whole system.