21 December 2022 in Nuclear and Radiation Safety
One of the key aspects for safety assessment of spent fuel dry storage systems is evaluation of the temperature profile for spent fuel in various storage conditions. In this effort, a three-dimensional model of a vertical dry storage HI‑STORM 190 UA system for VVER-1000 fuel is developed for ANSYS CFX code. This model is then used for the analysis of spent fuel thermal state in normal conditions and in a hypothetical case of a loss of the fuel canister integrity. Canister depressurization with helium leakage and its substitution with air lead to degradation of heat removal and increase of spent nuclear fuel temperature. The results presented in this article demonstrate that the maximum cladding temperature of spent fuel does not exceed the design limit in normal storage conditions. In the case of loss of the fuel canister integrity, the maximum cladding temperature exceeds this design limit for normal storage conditions, but remains below the limit for short-term off-normal conditions. The results also demonstrate that loss of the fuel canister integrity leads to insignificant change in vents outlet temperature and cannot be reliably identified by temperature monitoring according to the existing procedures.
15 September 2020 in Nuclear and Radiation Safety
One of the milestones leading to the unit transition to long-term operation is the assessment of the current technical state of equipment and pipelines during the periodic safety review. An integral part of this assessment are the strength calculations within the necessity to take into account rapid thermohydraulic parameters changing during non-stationary transients. Such calculations are characterized by the need for taking into account the relationship between equipment units and pipelines of the reactor coolant system. This task requires additional development of a complex three-dimensional FE model of reactor coolant system. The submodeling approach was used to perform the strength calculation of primary equipment. This approach involves the step-by-step process of strength calculations including the development of a thermohydraulic model with thermohydraulic analysis, the creation of a simplified complex finite element model of the reactor unit containing basic equipment and pipelines, validation, detailed transfer of boundary condition datasets for finite element model and determination of stress strain state for all calculation modes, and performance of the specified calculations of the equipment by a method of submodeling at the end. In general, the implementation of the whole complex of thermohydraulic and strength calculations within one program code is a quite complicated task and requires creating a separate approach. This paper presents the results of developing a comprehensive approach using the coupled calculations in the thermohydraulic and strength codes.