LaMnO3 powder synthesized by glycine combustion synthesis with the rhombohedral and orthorhombic structures has been characterized by the combination of low energy ion scattering (LEIS) and X-ray photoelectron spectroscopy (XPS), while the electrocatalytic activity for the oxygen reduction reaction is measured with the rotating disk electrode (RDE) method. Quantification of the surface terminations obtained by LEIS suggests that the orthorhombic LaMnO3 crystallites are near thermodynamic equilibrium as surface atomic ratios compare well with those of equilibrium morphologies computed by a Wulff construction based on computed surface energies. Both rhombohedral and orthorhombic structures present the same La/Mn atomic ratio on the surface. Electrochemical activity of the two structures is found to be the same within the error bar of our measurements. This result is in disagreement with results previously reported on the activity of the two structures obtained by the coprecipitation method [Suntivich et al. Nat. Chem. 2011, 3 (7), 546], and it indicates that the preparation method and the resulting surface termination might play a crucial role for the activity of perovskite catalysts.
The phase stability of LaMnO with respect to its competing oxides is studied using hybrid-exchange density functional theory (DFT) as implemented in crystal09. The underpinning DFT total-energy calculations are embedded in a thermodynamic framework that takes optimal advantage of error cancellation within DFT. It has been found that by using the ab initio thermodynamic techniques described here, the standard Gibbs formation energies can be calculated to a significantly greater accuracy than was previously reported (a mean error of 1.6% with a maximum individual error of 3.0%). This is attributed to both the methodology for isolating the chemical potentials of the reference states, as well as the use of the Becke, three-parameter, Lee-Yang-Parr (B3LYP) functional to thoroughly investigate the ground-state energetics of the competing oxides.
19 August 2019 in ACS Applied Materials & Interfaces
A series of Mo-doped BiVO 4 photoanodes are studied using experimental and DFT methods. Mo doping replaces V sites, increasing electronic conductivity and improving solar water splitting performance.
LaMnO3 is an inexpensive alternative to precious metals (e.g. platinum) as a catalyst for the oxygen reduction reaction in alkaline fuel cells. In fact, recent studies have shown that among a range of non-noble metal catalysts, LaMnO3 provides the highest catalytic activity. Despite this, very little is known about LaMnO3 in the alkaline fuel cells environment, where the orthorhombic structure is most stable. In order to understand the reactivity of orthorhombic LaMnO3 we must first understand the surface structure. Hence, we have carried out calculations on its electrostatically stable low index surfaces using hybrid-exchange density functional theory, as implemented in CRYSTAL09. For each surface studied the calculated structure and formation energy is discussed. Among the surfaces studied the (100) surface was found to be the most stable with a formation energy of 0.98 J m−2. The surface energies are rationalised in terms of the cleavage of Jahn–Teller distorted Mn–O bonds, the compensation of undercoordination for ions in the terminating layer and relaxation effects. Finally, the equilibrium morphology of orthorhombic LaMnO3 crystals is predicted, allowing us to speculate about likely surface reaction sites.