We analyze the role of coherent, non-perturbative system-bath interactions in a photosynthetic heat engine. Using the reaction-coordinate formalism to describe the vibrational phonon-environment in the engine, we analyze the efficiency around an optimal parameter regime predicted in earlier studies. We show that, in the limit of high-temperature photon irradiation, the phonon-assisted population transfer between bright and dark states is suppressed due to dephasing from the photon environment, even in the Markov limit where we expect the influence of each bath to have an independent and additive effect on the dynamics. Manipulating the phonon bath properties via its spectral density enables us to identify both optimal low- and high-frequency regimes where the suppression can be removed. This suppression of transfer and its removal suggests that it is important to consider carefully the non-perturbative and cooperative effects of system-bath environments in designing artificial photosynthetic systems and also that manipulating inter-environmental interactions could provide a new multidimensional “lever” by which photocells and other types of quantum devices can be optimized.
Rapid and continuous analysis of radiocarbon (14C) concentration in carbonate samples at spatial resolution down to 100 µm has been made possible with the new LA-AMS (laser ablation accelerator mass spectrometry) technique. This novel approach can provide radiocarbon data at a spatial resolution similar to that of stable carbon (C) isotope measurements by isotope ratio mass spectrometry of micromilled samples and, thus, can help to interpret δ13C signatures, which otherwise are difficult to understand due to numerous processes contributing to changes in the C-isotope ratio. In this work, we analyzed δ13C and 14C on the Holocene stalagmite SPA 127 from the high-alpine Spannagel Cave (Austria). Both proxies respond in a complex manner to climate variability. Combined stable carbon and radiocarbon profiles allow three growth periods characterized by different δ13C signatures to be identified: (i) the period 8.5 to 8.0 ka is characterized by relatively low δ13C values with small variability combined with a comparably high radiocarbon reservoir effect (expressed as dead carbon fraction, dcf) of around 60 %. This points towards C contributions of host rock dissolution and/or from an “old” organic matter (OM) reservoir in the karst potentially mobilized due to the warm climatic conditions of the early Holocene. (ii) Between 8 and 3.8 ka there was a strong variability in δ13C with values ranging from −8 ‰ to +1 ‰ and a generally lower dcf. The δ13C variability is most likely caused by changes in C exchange between cave air CO2 and dissolved inorganic carbon in drip water in the cave, which are induced by reduced drip rates as derived from reduced stalagmite growth rates. Additionally, the lower dcf indicates that the OM reservoir contributed less to stalagmite growth in this period possibly as a result of reduced meteoric precipitation or because it was exhausted. (iii) In the youngest section between 3.8 and 2.4 ka, comparably stable and low δ13C values, combined with an increasing dcf reaching up to 50 % again, hint towards a contribution of an aged OM reservoir in the karst. This study reveals the potential of combining high-resolution 14C profiles in speleothems with δ13C records in order to disentangle climate-related C dynamics in karst systems.
Context: The potential lifespan of alligator gar (Atractosteus spatula) is currently unknown. A previous study applied bomb radiocarbon (14C) dating to establish ages >60 years, but maximum age was limited by the rise of bomb-produced 14C in the 1950s. Aims: An exceptionally large specimen (2.6 m, 148 kg) was captured in Mississippi and otolith growth zones revealed an age estimate of 95 years. This specimen provided an opportunity to apply new technology to validate the lifespan of alligator gar. Methods: Developments in accelerator mass spectrometry (AMS) led to technology that measures 14C continuously from carbonates (laser ablation-AMS), as opposed to single sample 14C analysis. Key results: Use of laser ablation AMS on the 2.6-m alligator gar otolith, and two smaller fish aged >60 years, supported ages that were older than original estimates by 5–20 years. Conclusions: Our study indicates that alligator gar age can be underestimated for the largest fish, maximum recorded length is 2.6 m based on a historical photograph, and lifespan is at least 75–95 years with support for an age of 100 years for the 2.6-m fish. Implications: An increase in lifespan of this magnitude would affect our understanding of population dynamics and recovery efforts.
While simultaneous radiocarbon and δ13C measurements have been available for organic materials (by accelerator mass spectrometry, AMS, and isotope ratio mass spectrometry, IRMS, respectively), this has not been possible for carbonates until now. Using an existing interface for gas ion source AMS measurements, we developed a prototype for a universal gas interface that allows simultaneous measurement of both carbon isotope ratios from potentially any source of CO2. First results obtained from reference materials (IAEA-C6, OxaII, PhA, IAEA-C1, IAEA-C2, ETH-4) show that for both organic as well as carbonate samples, the precision of radiocarbon measurements in the coupled mode is comparable to routine standalone AMS measurements. For IRMS δ13C measurements, the performance for different materials shows more variation with precisions ranging from 0.07‰ to 0.47‰. However, both organic materials and carbonates can achieve precisions as good as 0.13‰. Once fully automated, the method shows potential for filling the gap of simultaneous carbon isotope measurements for non-organic materials.
The unique laser ablation (LA) setup at ETH Zurich (Switzerland), coupled to a MICADAS accelerator mass spectrometer (AMS), enables rapid 14C analyses and has been successfully employed for a broad range of carbonate archives such as stalagmites (Welte et al., 2021), otoliths (Andrews et al., 2019), and shells of Arctica islandica. An 193 nm ArF excimer laser is used to liberate CO and CO2 from the sample surface by ablation. The gas is then flushed with helium into the gas ion source of the AMS for online measurement.Advantages of the novel techniques are a significant reduction in labour-intensive sample preparation and the speed of measurement, which minimises the expensive beam-time of the AMS. However, as a transient signal is measured where each sampling location is only measured for a short duration, uncertainties associated with LA-AMS are significantly higher than for conventional measurement techniques. Still, it is possible to locate strong signals such as a growth stop or the bomb spike very rapidly and precisely using only two scans of the sample. Here we present the status of the setup and progress on data reduction aimed at reducing the larger uncertainties. Preliminary results from comparisons of parallel tracks on a stalagmite allow testing the data reduction strategy and will be shown.Andrews, A. et al. (2019), Marine and Freshwater Research, https://doi.org/10.1071/mf18265Welte, C. et al. (2021), Climate of the Past, 17(5), 2165–2177, https://doi.org/10.5194/cp-17-2165-202