1 July 2023 in at - Automatisierungstechnik
Continuum robots for application in medicine are of high interest in recent research. However, as most systems in literature show complex and large actuator units, setting up such a system can be time consuming, costly and results in a bulky system, unsuitable for the spatial requirements given in surgical scenarios. In this work, a compact, efficient continuum robotic system is presented. A pair of two antagonistic tendons is controlled by a single servo motor instead of single tendon actuation. This way, the actuator footprint is maintained at a minimum size and the method results in a simpler setup. The resulting 260 mm long robot with 9.9 mm diameter achieves a repeatability with an error of maximum 1.8 % of its length. In future work, this work serves as a basis for integration of various sensing modalities in continuum robots and evaluation of control algorithms.
1 August 2021 in Current Directions in Biomedical Engineering
Smart medical phantoms for training and evaluation of endovascular procedures ought to measure impact forces on the vessel walls worth protecting to provide feedback to clinicians and articulated soft robots. Recent commercial smart phantoms are expensive, usually not customizable to different applications and lack accessibility for integrated development. This work investigates piezoresistive films as highly integratable flexible sensors to be used in arbitrary soft vessel phantom anatomies over large surfaces and curved shapes providing quantitative measurement in the force range up to 1 N with 0.1 N resolution. First results show promising performance at the point of calibration and in a 5 mm range around it, with absolute measuring error of 28 mN and a standard deviation of ±10 mN and response times <500 ms. Future work shall address the optimization of response time and sensor shapes as well as the evaluation with experienced clinicians.
1 August 2021 in Current Directions in Biomedical Engineering
Robots from material-based actuators offer high potential for small-scale robots with abilities hardly achievable by classical methods like electric motors. Besides excellent scaling to minimally invasive systems, allowing for omission of metallic components, such robots can be applied in imaging modalities such as MRI or CT. To allow for higher accessibility in this field of research, a facile method for fabrication of such soft actuators was developed. It comprises only two materials: graphene oxide and silicone elastomer. The facile fabrication method does not require specialized equipment. The resulting actuator is biocompatible and controllable by light mediated heat. The bending motion can be controlled by the intensity of applied infrared light and the actuator was experimentally shown to move five times its own weight. Thus, providing capabilities for a medical soft robotic actuator.
23 September 2024 in IEEE Transactions on Medical Robotics and Bionics
Minimally invasive continuum robots face limitations in accessing environmental and spatial information on the situs. However, such information would often be necessary for control and automation features in surgical use. Centering an endoscopic system within a hollow organ can be such a feature, providing the benefit of reduced risk of injury and assistance for navigation. To leverage such an application, this work investigates a proximity servoed continuum robot. A sensorized tip combines capacitive electrodes, a camera, and illumination and uses capacitive proximity sensing to determine the enclosing environment’s center point. A controller is presented that uses this information to center the robot’s tip. The system is evaluated in a dynamic phantom, where an average accuracy of 10.0 mm could be demonstrated and contact to the phantom’s wall was avoided during 98% of the experiment time. In a second phantom experiment, it is demonstrated how this controller can be applied to follow the center line of a bent anatomical structure. Future work should focus on improving accuracy and versatility of the system, aiming for application in more challenging and irregular environments, such as ex vivo or in vivo organs.