27 December 2018 in Angewandte Chemie International Edition
3 June 2015 in Angewandte Chemie International Edition
1 November 2016 in Energy Procedia
The silver grid corrosion phenomenon of c-Si solar cells, often called “snail trails” or “snail tracks”, which occurs mainly shortly after installation of PV modules in the field, was first observed approximately one decade ago in the southern part of Europe. It was recognized quickly that these discolorations on the metal grid fingers are always accompanied by cell (micro) cracks. From the herein presented investigations, it can be shown that several different chemical mechanisms and material involvements can lead to the visual phenomenon of silver grid finger discoloration. It must therefore be clarified that the term “snail track” (or “snail trails”) only describes a failure class and not a single degradation mechanism. This work focuses on a bottom up approach, which includes the chemical analyses of the affected cell parts extracted from various industrial modules which have been installed in the field. In addition to the analytical investigations after field failure, the modules are exposed to artificial stresses to investigate the development, formation or further reaction of the snail track degradation products. Since the phenomenon is always accompanied by diffusion open areas in the module (cell gaps, cell cracks), the diffusion of reactant partners from the rear side of the module, e.g. atmospheric gases or additives from the back sheet material, has been the most suspected root cause from the beginning of the observation. The role of these reaction partners is therefore highlighted within the results. Four different snail track degradation products have been identified until now: Silver carbonate, silver sulfide, silver phosphate and silver acetate. Silver sulfide snail tracks were only found after damp-heat test (only artificially induced), all other types were found from field failed PV modules and respectively partially from stress tests. The different snail track types, materials and module components considered being involved and the formation mechanisms are presented in this work
6 March 2023 in Energy & Fuels
27 December 2018 in Angewandte Chemie
15 October 2019 in Journal of Materials Chemistry A
Manganese oxide coated carbon fibre paper electrodes (MnOx/CFP), prepared via an easily scalable redox-deposition route, have been reported as promising materials for electrochemical water oxidation catalysis (WOC). In the study presented here, the catalyst mass-dependence of the activity of such nanostructured WOC electrodes and their activity and stability in phosphate buffer electrolytes over nearly the entire pH range (pH 1–14) was explored. For all pH values, current densities of >1 mA cm−2 at overpotentials η of 350–500 mV were observed, which are very good values for electrodes containing only earth-abundant elements (Mn, O and C in this case). The very decent performance observed for the mildly acidic pH regime (pH 2–6) was especially noteworthy. For the dependence of η on the pH, an ideal Nernstian behaviour was detected for the pH window pH 1–10. Above pH 10, a pronounced deviation from the expected trend was found, as most electro-kinetic parameters indicated even higher activities for the strongly alkaline regime. Concerning anode stabilities, current-densities of 2 mA cm−2 could be maintained at all studied pHs over at least 24 h of continuous operation. Pre- and post-operando spectroscopic analyses (e.g. vibrational and X-ray absorption spectroscopy, scanning electron microscopy) revealed only minor changes of the catalyst structure, composition, morphology or the average Mn oxidation state induced by the electrocatalytic operation, which confirms the good stabilities found in the electrochemical measurements. Thus, we report on an earth-abundant, easily-prepared type of WOC electrode, which exhibits promising activities and stabilities for applications in alkaline, neutral and even acidic electrolytes.