16 January 2013 in Science China Technological Sciences
1 January 2019 in Mathematical Problems in Engineering
This paper takes a cross section of 6 × 7 + IWS wire rope as an example to complete the studies on a method of geometric modeling for no‐joint wire rope and implementation of a 3D solid model. Frenet–Serret frame theory establishes three types of Frenet–Serret frame, which are double‐helix winding straight line, single‐helix winding arc, and double‐helix winding arc, and it allows derivation of eight types of center line equation of wire. This paper has ascertained tangent condition of center lines of steel wires with the same name between arc and straight‐line wire rope and closed condition of no‐joint wire rope. It has been concluded that the length of steel wire must be an integer multiple of its lay pitch either in arc wire rope or in straight‐line wire rope, and the name of wires in each wire rope must be consistent at the same time. Finally, using Pro/ENGINEER Wildfire 5.0 software generates a 3D solid model of no‐joint wire rope.
1 January 2021 in Advances in Materials Science and Engineering
This study mainly conducts the research on the discontinuous contact elastic properties of wire rope based on WR‐CVT. The geometry model and finite element model of continuous contact and discontinuous contact of 2/3 lay pitch wire rope are established. And the contact stress distribution of the steel wire is analyzed through 5 sections and 5 contact points. The results show that on the C‐C plane, the contact stress of the discontinuous contact model is 229.4 MPa higher than that of the continuous contact, but this difference is not obvious on the D‐D plane. The contact stress nephogram is elliptical, but in the noncontact area, the shape of the contact trace shows a distinct noncomplete ellipse, and the contact trace is distributed along the spiral trajectory of the steel wire. Point 4 due to the reduction in contact area, compared with continuous contact, discontinuous contact shows a higher stress value. The geometric dimensions of the wear scars of continuous contact and discontinuous contact indicate that regardless of the length of the wear scar or the width of the wear scar, the geometric characteristics of steel wire wear mark in discontinuous contact are larger than that in continuous contact, so the discontinuous contact aggravates the surface wear of wire. This research lays a theoretical foundation for the discontinuous contact wear and fatigue of WR‐CVT wire rope and other components.