We compare the quality factor values of the whispering gallery modes of microdisks (μ-disks) incorporating GaN quantum dots (QDs) grown on AlN and AlGaN barriers by performing room temperature photoluminescence (PL) spectroscopy. The PL measurements show a large number of high Q factor resonant modes on the whole spectrum, which allows us to identify the different radial mode families and to compare them with simulations. We report a considerable improvement of the Q factor, which reflects the etching quality and the relatively low cavity loss by inserting QDs into the cavity. GaN/AlN QDs-based μ-disks show very high Q values () whereas the Q factor is only up to 2000 in μ-disks embedding QDs grown on the AlGaN barrier layer. We attribute this difference to the lower absorption below bandgap for AlN barrier layers at the energies of our experimental investigation.
We report the demonstration of single-photon emission from cubic GaN/AlN quantum dots grown by molecular beam epitaxy. We have observed spectrally clean and isolated emission peaks from these quantum dots. Clear single-photon emission was detected by analyzing one such peak at 4 K. The estimated g(2)[0] value is 0.25, which becomes 0.05 when corrected for background and detector dark counts. We have also observed the single-photon nature of the emission up to 100 K (g(2)[0] = 0.47). These results indicate that cubic GaN quantum dots are possible candidates for high-temperature operating UV single-photon sources with the possibility of integration into photonic nanostructures.
An original method to fabricate III-nitride photonic crystal membranes without etching of III-N materials is reported. A photonic crystal pattern is first realized in a silicon substrate. GaN quantum dots embedded in a thin AlN layer are then grown by conformal epitaxy using ammonia-based molecular beam epitaxy on the top of the patterned silicon substrate and a free-standing membrane is achieved by selective etching of the silicon substrate through the holes of the photonic crystal. Room temperature microphotoluminescence measurements show a quality factor as high as 1800 at 425 nm on a modified L3 cavity. Possibility to achieve lasing with this system is discussed.