Husheng Zhang

Husheng Zhang

Auto-generated profile, based on publicly available information

Husheng Zhang

Institute of Mechanics 1 State Key Laboratory of Nonlinear Mechanics Chinese Academy of Sciences, No. 15, North 4th Ring, West Road, Beijing 100190, China

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 April 2017 in Journal of Applied Physics
Verified
Journal Article
Open access
WWWei Wang
Wei Wang
HZHusheng Zhang
Husheng Zhang
MYMuxin Yang
Muxin Yang
PJPing Jiang
Ping Jiang
Fuping YuanFuping Yuan
Fuping Yuan
XWXiaolei Wu
Xiaolei Wu
A series of plate-impact experiments were conducted to investigate the influences of impact stress and microstructure on the shock and spall behaviors of a high specific strength steel (HSSS). The HSSS shows a strong positive strain rate sensitivity on the yield strength. With increasing impact stress up to about 6 GPa, the spall strength is found to decrease significantly and then levels off with further increasing impact stress. This trend is proposed to be attributed to the accumulation damage within the target as the initial shock-induced compression wave propagates through the target. The microcracks are clearly observed to nucleate from the interfaces between γ-austenite and B2 phase and propagate along the interfaces or cut through the B2 phase in the HSSS during the spalling process. The Hugoniot elastic limit and the spall strength were found to be highly dependent on the microstructure. The spall strength was found to be higher when the density of the void nucleation sites is lower, indicating that the spall strength should be a microstructure parameter of the HSSS under impact tensile conditions depending on the density of phase interfaces. It was also found that there is a tradeoff between the specific yield strength and the spall strength for this HSSS; thus, the current findings should provide insights for achieving an optimal combination of both mechanical properties for impact-resistant applications by tailoring the microstructure.

1 March 2017 in Journal of Alloys and Compounds
Verified
Journal Article
Open access
WZWeigui Zhang
Weigui Zhang
YYYicong Ye
Yicong Ye
LHLiangju He
Liangju He
PLPeijie Li
Peijie Li
HZHusheng Zhang
Husheng Zhang

1 April 2016 in AIP Advances
Verified
Journal Article
Open access
PDF file
HZH. S. Zhang
H. S. Zhang
MYM. Yan
M. Yan
HWH. Y. Wang
H. Y. Wang
LSL. T. Shen
L. T. Shen
Lanhong DaiLanhong Dai
Lanhong Dai
A series of plate impact shock-reshock and shock-release experiments were conducted by using an one-stage light gas gun to determine the critical shear strength of the 2024 aluminum alloy under shock compression levels ranging from 0.66 to 3.05 GPa in the present study. In the experiments, a dual flyer plate assembly, i.e., the 2024 aluminum alloy flyer backed either by a brass plate or a PMMA plate, was utilized to produce reshock or release wave. The stress profiles of uniaxial plane strain wave propagation in the 2024 aluminum alloy sample under different pre-compressed states were measured by the embedded stress gauges. The stress-strain data at corresponding states were then calculated by a Lagrangian analysis method named as path line method. The critical shear strengths at different stress levels were finally obtained by self-consistent method. The results show that, at the low shock compression level (0.66 to 3.05 GPa), the critical shear strength of the 2024 aluminum alloy cannot be ignored and increases with the increasing longitudinal stress, which may be attributed to rate-dependence and/or pressure dependent yield behavior of the 2024 aluminum alloy.