27 July 2016 in Journal of Applied Physics
Interfacial atomic diffusion, reaction, and formation of microstructure in nanoscale level are investigated in W/B4C multilayer (ML) system as functions of thickness in ultrathin limit. Hard x-ray reflectivity (XRR) and x-ray diffuse scattering in conjunction with x-ray absorption near edge spectroscopy (XANES) in soft x-ray and hard x-ray regimes and depth profiling x-ray photoelectron spectroscopy (XPS) have been used to precisely evaluate detailed interfacial structure by systematically varying the individual layer thickness from continuous-to-discontinuous regime. It is observed that the interfacial morphology undergoes an unexpected significant modification as the layer thickness varies from continuous-to-discontinuous regime. The interfacial atomic diffusion increases, the physical density of W layer decreases and that of B4C layer increases, and further more interestingly the in-plane correlation length decreases substantially as the layer thickness varies from continuous-to-discontinuous regime. This is corroborated using combined XRR and x-ray diffused scattering analysis. XANES and XPS results show formation of more and more tungsten compounds at the interfaces as the layer thickness decreases below the percolation threshold due to increase in the contact area between the elements. The formation of compound enhances to minimize certain degree of disorder at the interfaces in the discontinuous region that enables to maintain the periodic structure in ML. The degree of interfacial atomic diffusion, interlayer interaction, and microstructure is correlated as a function of layer thickness during early stage of film growth.
30 October 2006 in Applied Physics Letters
The authors report determination of interlayer composition with subnanometer sensitivity at the buried interfaces using soft x-ray resonant reflectivity technique. Near the absorption edge, fine structure features of energy-dependent atomic scattering factor are sensitive to the composition, and can be exploited for determination of composition at the buried interfaces. This technique is demonstrated for a Mo–Si multilayer system using soft x-ray resonant reflectivity measurement.
7 December 2002 in Physica B: Condensed Matter
29 February 2016 in Journal of Physics D: Applied Physics
Microstructure limited reflectivity of sputter deposited ultra-short period W/B 4 C multilayers (MLs) has been studied using x-ray reflectivity, diffuse scattering and transmission electron microscopy (TEM). In order to understand the W-B 4 C interface in the near-discontinuous range, the thickness of the constituent layers was systematically varied between 0.5 nm and 2.5 nm. Good density contrast and minimal thickness error were observed in MLs with individual layer thickness higher than ~1.1 nm. However, below 1.1 nm one enters into a regime where the individual layers become discontinuous, leading to embedded growth of the two constituent layers. Consequently, a significant loss of x-ray contrast was observed. In addition, increased area of contact between W and B 4 C enhances the fraction of tungsten compound resulting in a layer thickness error. Based on these findings, large repetition (upto 400 bilayers) MLs with ultra-short period (down to 1.6 nm) were optimized to achieve reflectivity as high as 53% and resolving power of 149, at 8.047 keV.
22 August 2013 in Applied Optics
A multilayer structure consisting of alternate layers of W and has been deposited using a magnetron sputtering system. The structure of the as-deposited and vacuum-annealed multilayer sample has been characterized using grazing incidence x-ray reflectivity, grazing incidence diffraction, and the normal incidence reflectivity has been measured using synchrotron radiation. A two-layer model consisting of tungsten and boron carbide is presented. The multilayer structure was found to be stable after 800°C annealing. Grazing incidence x-ray diffraction measurements suggested that W is polycrystalline with small grain size. No signature of tungsten carbide or tungsten boride formation could be observed during the annealing treatments. A near normal incidence soft x-ray reflectivity (SXRR) of was obtained at 6.8 nm wavelength. A little drop () in SXRR after 800°C annealing suggested that there were no compositional changes within the layers during the annealing treatments.
1 July 2006 in Journal of Electron Spectroscopy and Related Phenomena