Kyusun Choi

Kyusun Choi

Auto-generated profile, based on publicly available information

Kyusun Choi

The Pennsylvania State University

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2004 in Analog Integrated Circuits and Signal Processing
Verified
Journal Article
Closed access
PDF file
ATAli Tangel
Ali Tangel
KCKyusun Choi
Kyusun Choi

25 September 2009 in IEEE Transactions on Biomedical Circuits and Systems
Verified
Journal Article
Closed access
Insoo KimInsoo Kim
Insoo Kim
HKHyunsoo Kim
Hyunsoo Kim
FGFlavio Griggio
Flavio Griggio
RTRichard L. Tutwiler
Richard L. Tutwiler
TJThomas N. Jackson
Thomas N. Jackson
KCKyusun Choi
Kyusun Choi
The proposed CMOS ultrasound transceiver chip will enable the development of portable high resolution, high-frequency ultrasonic imaging systems. The transceiver chip is designed for close-coupled MEMS transducer arrays which operate with a 3.3-V power supply. In addition, a transmit digital beamforming system architecture is supported in this work. A prototype chip containing 16 receive and transmit channels with preamplifiers, time-gain compensation amplifiers, a multiplexed analog-to-digital converter with 3 kB of on-chip SRAM, and 50-MHz resolution time delayed excitation pulse generators has been fabricated. By utilizing a shared A/D converter architecture, the number of A/D converter and SRAM is cut down to one, unlike typical digital beamforming systems which need 16 A/D converters for 16 receive channels. The chip was fabricated in a 0.35-mum standard CMOS process. The chip size is 10 mm2, and its average power consumption in receive mode is approximately 270 mW with a 3.3-V power supply. The transceiver chip specifications and designs are described, as well as measured results of each transceiver component and initial pulse-echo experimental results are presented.

25 May 2017 in Circuits, Systems, and Signal Processing
Verified
Journal Article
Closed access
PDF file
AAAbdulrahman Abumurad
Abdulrahman Abumurad
KCKyusun Choi
Kyusun Choi

14 January 2019 in Circuits, Systems, and Signal Processing
Verified
Journal Article
Closed access
PDF file
AAAbdulrahman Abumurad
Abdulrahman Abumurad
AOAli Ozdemir
Ali Ozdemir
KCKyusun Choi
Kyusun Choi

1 December 2008 in IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences
Verified
Journal Article
Closed access
PDF file
Insoo KimInsoo Kim
Insoo Kim
JYJincheol Yoo
Jincheol Yoo
JKJongSoo KIM
JongSoo KIM
KCKyusun Choi
Kyusun Choi
Threshold Inverter Quantization (TIQ) technique has been gaining its importance in high speed flash A/D converters due to its fast data conversion speed. It eliminates the need of resistor ladders for reference voltages generation which requires substantial power consumption. The key to TIQ comparators design is to generate 2n - 1 different sized TIQ comparators for an n-bit A/D converter. This paper presents a highly efficient TIQ comparator design methodology based on an analytical model as well as SPICE simulation experimental model. One can find any sets of TIQ comparators efficiently using the proposed method. A 6-bit TIQ A/D converter has been designed in a 0.18µm standard CMOS technology using the proposed method, and compared to the previous measured results in order to verify the proposed methodology.

25 June 2003
Verified
Conference Paper
Closed access
JYJincheol Yoo
Jincheol Yoo
DLDaegyu Lee
Daegyu Lee
KCKyusun Choi
Kyusun Choi
JKJongsoo Kim
Jongsoo Kim
A new power and resolution adaptive flash ADC, named PRA-ADC, is proposed. The PRA-ADC enables exponential power reduction with linear resolution reduction. Unused parallel voltage comparators are switched to standby mode. The voltage comparators consume only the leakage power during the standby mode. The PRA-ADC, capable of operating at 5-bit, 6-bit, 7-bit, and 8-bit precision, dissipates 69 mW at 5-bit and 435 mW at 8-bit. The PRA-ADC was designed and simulated with 0.18 /spl mu/m CMOS technology. The PRA-ADC design is applicable to RF portable communication devices, allowing tighter management of power and efficiency.