Fault deformation can cause severe damage to structures located within the fault zones. A logarithmic spiral model was developed by D. A. Cole and P. V. Lade in 1984 to predict the shapes and locations of fault ruptures in sand caused by dip–slip faulting, based on 1g sandbox tests. However, it shows poor predictions for reverse fault ruptures observed in centrifuge tests. In this study, centrifuge modelling of reverse faulting was performed to explore the reasons for the poor predictions by the logarithmic spiral model. These faulting tests were conducted in free-field conditions with different sand densities and soil thicknesses. Based on results of centrifuge tests from both the present study and previous research studies, a hyperbolic spiral model is proposed to predict approximately the shapes and locations of reverse fault ruptures in sand. The results show that the 45° − ϕmax/2 rather than 45° − ψmax/2 controls the surface direction angle of the outcropping rupture. Validation of the hyperbolic spiral model shows a promising prediction in centrifuge tests both in the present study and previous research studies.
In this paper, the displacement data of a segment lining structure in a similar model test were analyzed in depth based on a field investigation and the analysis of a cracked segment in a metro project. In doing so, we proved the displacement characteristics and bearing capacity of shield tunnel segments with different cracks numbers, lengths, and locations. The results showed that the presence of a crack decreases the overall stiffness of the structure relative to an undamaged segment ring and causes the deformation increases with the same load to increase. One-third of the width of a segment is the demarcation point at which the length of the crack begins to affect the mechanical properties of structure of the lining of the segment. When the length of the crack is larger than one-third the width of the segment, the instability of the structure tends to result in sudden failure. Although an increase in the number of cracks does not reduces the ultimate bearing capacity of the structure further, the deformation of the structure of the lining of the segment increases significantly as the number of cracks increases. compared to a crack at the vault and at the arch waist, the ultimate bearing capacity of the segment is the same when the crack is at the bottom of the arch, but the effects of cracks located at the arch bottom in the structural deformation are the most significant.