A novel technique for increasing the sensitivity of tilted fibre Bragg grating (TFBG) based refractometers is presented. The TFBG sensor was coated with chemically synthesized silver nanowires ~100 nm in diameter and several micrometres in length. A 3.5-fold increase in sensor sensitivity was obtained relative to the uncoated TFBG sensor. This increase is associated with the excitation of surface plasmons by orthogonally polarized fibre cladding modes at wavelengths near 1.5 μm. Refractometric information is extracted from the sensor via the strong polarization dependence of the grating resonances using a Jones matrix analysis of the transmission spectrum of the fibre.
13 November 2014 in The Journal of Physical Chemistry C
Plasmonic properties, such as refractive index sensitivity (RIS), surface enhancement of the Raman signal (SERS), fluorescence quenching, and photocatalytic activity, of monolayers of weakly interacting monodisperse silver nanocubes were qualitatively modified in a very well controlled manner by supporting them on thin silicon films with varying thickness. Such fine tunability is made possible by the strong dependence of the nanocube dipolar (D) and quadrupolar (Q) plasmon mode hybridization on the refractive index of the supporting substrate. By increasing the Si film thickness from zero to ∼25 nm we were able to “shift” the D resonance mode by up to 200 nm for ∼80 nm cubes without significantly affecting the Q mode. The silicon supported nanocubes showed a significant improvement in RIS via the Q mode with a figure of merit greater than 6.5 and about an order of magnitude enhancement of the SERS signal due to the stronger electric field created by the D mode. Such substrates also showed a ∼10 times decrease in rhodamine 6G fluorescence as well as the rates of amorphous carbon formation. The study proposes a new way to design and engineer plasmonic nanostructures.
Integration of nanoparticles into thin films is essential for the development of functional materials, studies of fundamental interfacial processes, and exploitation of inherent properties from the particles themselves. In this work, we systematically investigate the process of incorporation of silver nanocubes into thin polystyrene films at temperatures just above the polymer glass transition. The process of nanocrystal incorporation can be precisely monitored via far-field spectroscopy to observe the response of spatially resolved hybrid plasmon modes. Each plasmon resonance has a distinct dynamic range and maximum sensitivity forming a complementary set of nanorulers that operates over a distance comparable to the edge length of the cubes. The approach explored in this work is a general robust method for the development of long-range polychromatic nanorulers.
14 December 2018 in Journal of Materials Chemistry A
Silver and copper are each widely-studied metals for catalyzing the CO2 reduction reaction (CO2RR), yet studies of Ag–Cu alloys are very rare due to the immiscibility of the two metals. Reported herein is a synthetic route that provides access to Ag–Cu alloys at ambient pressures and temperatures. This method involves solution-depositing a homogeneous mixture of silver(I) 2-ethylhexanoate and copper(II) bis-(2-ethylhexanoate) on a substrate, and photolyzing the thin films with ultraviolet light in an inert dinitrogen atmosphere. This photodeposition procedure is shown to furnish metastable phases of alloys with ∼10 atomic weight% (at%) copper incorporated into the silver lattice. The CO2RR activity of the alloyed sample shows a preference for forming CH4 rather than CO or HCO2− favored for our pure silver and copper films, respectively. These results provide proof that photodeposition can be used to access kinetic phases of alloys that are useful for heterogeneous reaction chemistry.