4 August 2022 in Journal of Physics: Condensed Matter
As the development of wireless communication devices tends to be highly integrated, the miniaturization of very low frequency (VLF) antenna units has always been an unresolved issue. Here, a novel VLF mechanical communication antenna using magnetoelectric (ME) laminates with bending-mode structure is realized. ME laminates combines magnetostrictive Metglas amorphous ribbons and piezoelectric 0.7Pb(Mg1/3Nb2/3)O3–0.3PbTiO3 single crystal plates. From the simulation, we confirmed that the ME laminates can reduce the resonance peak from 18 kHz to 7.5 kHz by bending-mode structure. Experiment results show the resonance frequency can be farther reduced to 6.3 kHz by clamping one end of the ME antenna. The ME laminate exhibits a giant converse ME coefficient of 6 Oe cm V−1 at 6.3 kHz. The magnetic flux density generated by the ME antenna has been tested along with distance ranging from 0 to 60 cm and it is estimated that a 1 fT flux could be detected around 100 m with an excitation power of 10 mW.
26 October 2023 in IEEE Antennas and Wireless Propagation Letters
High conductive environments such as deep earth and seawater bring challenges to existing electronic communication technology. Very Low Frequency (VLF) communication technology is supposed to be a feasible solution for conductive environments communication due to its improved radiation attenuation. Herein, we report a VLF 2 Frequency Shift Keying (2FSK) signal receiving antenna based on Metglas/0.7Pb(Mg 1/3 Nb 2/3 )O 3 –0.3PbTiO 3 (PMN-PT) magnetoelectric (ME) cantilever. The cantilever beam is predicted by finite element simulation and shows double electromechanical resonance (EMR) peaks. Experimental results reveal that the ME cantilever demonstrate strong resonant ME coupling coefficients as high as α Q ⁓ 100 nC/Oe at 6 kHz and 18 kHz, which ensures the high responsivity and low bit error rate during modulation in FSK communication application. The noise equivalent magnetic field of the whole antenna system at the resonant peak is measured to be as low as 12.56 fT/Hz 1/2 (at 18.44 kHz), implying a huge signal to noise ratio (SNR) advantage. On the basis of the above preparation, the ability of ME antenna to receive 2FSK signal is verified. ME antenna shows good performance on demonstrate FSK signals reception which is 200 bit/s. Such an ME composite based mechanical antenna shows great potential in the conductive environmental communication application.