We design and demonstrate a compact and low-power, band-engineered, electro-optic (EO) polymer refilled silicon slot photonic crystal waveguide (PCW) modulator. The EO polymer is engineered for large EO activity and near-infrared transparency. A PCW step coupler is used for optimum coupling to the slow-light mode of the band-engineered PCW. The half-wave switching voltage is measured to be over an optical spectrum range of 8 nm, corresponding to the effective in-device of and in a push–pull configuration. Excluding the slow-light effect, we estimate that the EO polymer is poled with an efficiency of in the slot.
We investigate the loss mechanism in three-moded multimode-interference couplers that are the building blocks of a compact and low-loss waveguide crossing structure. Broadband silicon waveguide crossing arrays with insertion loss per crossing are proposed using cascaded multimode-interference couplers, where lateral subwavelength nanostructures are used to reduce the insertions loss. We design and fabricate a waveguide crossing array with a pitch of 3.08 μm. Insertion loss of per crossing and crosstalk at 1550 nm operating wavelength and a broad transmission spectrum ranging from 1520 to 1610 nm are experimentally demonstrated.
Design and fabrication of a two-mode interference (TMI) coupler based on-chip polarization splitter is presented. By changing the angle between the access waveguides, one can tune the effective TMI length for the mode with less optical confinement (transverse magnetic, TM) to coincide with the target TMI length for a desired transmission of the mode with higher optical confinement (transverse electric, TE). The fabricated long TMI splits the input power into TM (bar) and TE (cross) outputs with splitting ratio over over bandwidth. Fabrication tolerance analysis shows that the device is tolerant to fabrication errors as large as .
We present a dispersion engineered slow light silicon-based photonic crystal waveguide PIN modulator. Low-dispersion slow light transmission over 18nm bandwidth under the silica light line with a group index of 26.5 is experimentally confirmed. We investigate the variations of the modulator figure of merit, Vπ × L, as a function of the optical carrier wavelength over the bandwidth of the fundamental photonic crystal waveguide defect mode. A large signal operation with a record low maximum Vπ × L of 0.0464 V⋅mm over the low-dispersion optical spectral range is demonstrated. We also report the device operation at 2GHz.
20 November 2013 in IEEE Journal of Selected Topics in Quantum Electronics
We present a high yield and high sensitivity on-chip biosensing system by combining subwavelength grating coupling and high sensitivity photonic crystal microcavity side coupled to a photonic crystal waveguide. 80% yield of working devices was experimentally demonstrated for sensitivity engineered L13 photonic crystal microcavities and 70% for L21 photonic crystal microcavities. Subwavelength grating couplers significantly improved the quality of the output transmission spectrum. By engineering the optical loss rate from the cavity to the waveguide, we experimentally detected 1 pM (67 pg/ml) and 50 femto-molar (3.35 pg/ml) concentration of avidin binding to biotin in phosphate buffered saline for L21 and L55 PC microcavities respectively, which represents the highest sensitivity versus other chip-based optical biosensors.