Yizhuo Feng

Yizhuo Feng

Auto-generated profile, based on publicly available information

Yizhuo Feng

Brunel University of London

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 December 2022 in Fuel
Verified
Journal Article
Closed access
ZLZhen Lu
Zhen Lu
MMMenghao Ma
Menghao Ma
TWTianyou Wang
Tianyou Wang
TLTianlong Lu
Tianlong Lu
HWHuaiyin Wang
Huaiyin Wang
LSLei Shi
Lei Shi

1 November 2021 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
JCJunqian Cai
Junqian Cai
KSKai Sun
Kai Sun
YFYizhuo Feng
Yizhuo Feng
Ming JiaMing Jia
Ming Jia
ZLZhen Lu
Zhen Lu
TWTianyou Wang
Tianyou Wang
Turbulent jet ignition (TJI) is a promising technology that enables engines to operate stably at ultra-lean-burn conditions for improved thermal efficiency. In the present work, TJI of an ultra-lean methane/air mixture (excessive air ratio λ = 2.0) under an engine-like condition (temperature of 900 K and pressure of 5.8 MPa) was numerically studied, with particular interest on the ignition patterns and the critical/favorable conditions for successful ignition/rapid combustion. A high-fidelity large eddy simulation was performed, with the linear eddy model being incorporated to account for turbulence–chemistry interaction. To represent the different amount/state of energy released from a pre-chamber, a variety of turbulent jet temperatures, inlet velocities, and orifice diameters were covered. The results identified two successful ignition patterns, including a flame propagation pattern and a jet re-ignition pattern. An ignition regime was also established, with the boundary between ignition success/failure identified by a global Damköhler number (Da) of 0.1. In terms of the combustion rate, heat release in the propagative flame is governed by the growth of the flame surface, which is primarily controlled by stretch and enlarges with the jet Reynolds number (Re). The present results suggest that, for low-reactivity fuels such as methane, the pre-chamber combustion in a TJI system should pursue complete heat release and increase Re and Da simultaneously for the injected turbulent jet into the main combustion chamber.

3 February 2023 in Fuel
Verified
Journal Article
Closed access
YFYizhuo Feng
Yizhuo Feng
KSKai Sun
Kai Sun
YLYaozong Li
Yaozong Li
HBHonglin Bai
Honglin Bai
LSLei Shi
Lei Shi
TWTianyou Wang
Tianyou Wang

27 April 2023 in Fuel
Verified
Journal Article
Closed access
YFYizhuo Feng
Yizhuo Feng
TSTansu Shang
Tansu Shang
JCJunqian Cai
Junqian Cai
KSKai Sun
Kai Sun
TWTianyou Wang
Tianyou Wang

2 July 2025 in International Journal of Engine Research
Verified
Journal Article
Open access
MMMOHAMED A S MOHAMED
MOHAMED A S MOHAMED
YFYizhuo Feng
Yizhuo Feng
XWXinyan Wang
Xinyan Wang
HZHua Zhao
Hua Zhao
JHJonathan Hall
Jonathan Hall
Recent development of hydrogen (H 2 ) internal combustion engine (ICE) technologies has demonstrated that they produce zero CO 2 and ultra-low NO X emissions without aftertreatment. Therefore, H 2 ICE is well suited as a sustainable zero-carbon thermal power unit towards the net-zero target in the future. Increasing the compression ratio (CR) in IC engines can improve the indicated thermal efficiency (ITE). However, in spark ignition (SI) engines using gasoline, the CR is typically limited to around 10:1 due to knocking combustion. Hydrogen, with its higher autoignition temperature and octane number, can be used with a higher CR. This study aims to experimentally assess hydrogen as a direct replacement for gasoline in highly boosted single-cylinder SI engines with different CRs by swapping engine pistons. Two sets of experimental testing have been conducted at various engine speeds. Starting from a lambda (λ) sweep test involved leaning out the combustion to reach the engine stability-operating limits. The second test involved conducting a load sweep test on every CR at various loads to get the engine’s maximum in-cylinder pressure limits. The results indicate that, under the synergistic restriction of the engine strength and the lean-burn limitation, there is a crucial trade-off between peak and maximum engine power with various CR. Specifically, a higher compression ratio (i.e. CR = 12.39) resulted in a 5% increase in ITE compared to CR = 9.27. However, the lower compression ratio increased the maximum engine torque by 3.50 bar of indicated mean effective Pressure (IMEP). In addition, although hydrogen can remain stable combustion across a broad range of lambda and operating loads, the NO X emissions increased with CR, due to the higher combustion temperature. These findings provide valuable insight into hydrogen engine applications and improve the understanding of SI hydrogen engine’s performance and development.