16 October 2017 in Journal of Lightwave Technology
In this study, we demonstrate the intermediate-frequency-over-fiber (IFoF) based mobile fronthaul technology implemented in a 28 GHz millimeter-wave (mmWave) based 5G prototype supporting Giga-bit mobile broadband services. In order to confirm the technical feasibility of the proposed IFoF based mobile fronthaul, the clock signal for frequency synchronization and mobile payload data are simultaneously transmitted in the form of IF carriers. Phase noise (PN) and error vector magnitude (EVM) measurements were performed on separate and simultaneous clock transmission paths, respectively. The results confirm an acceptable impact on performance, and the simultaneous clock transmission method reduces system costs and complexity, and improves the flexibility and efficiency of wavelength operation. We also successfully demonstrate the operation of real-time Giga-bit mobile services such as 4K video streaming over IFoF based mobile fronthaul for 5G prototypes with a 28 GHz mmWave. The achieved peak data-rate per user is up to 1.5 Gb/s, which complies with the requirements of the 5G vision of IMT-2020.
20 September 2019 in Journal of Lightwave Technology
In this study, we report the successful demonstration of an intermediate-frequency-over-fiber (IFoF)–based radio access network (RAN) for 28 GHz millimeter-wave (mmWave)-based 5G mobile communication. In order to increase the network coverage of the mmWave-based 5G networks, we propose a distributed antenna system (DAS) that uses the IFoF technology. An IFoF-based DAS with 2 × 2 multiple-input multiple-output (MIMO) configuration was deployed in the PyeongChang area to provide 5G trial demonstration during the Winter Olympics. 5G trial services such as high-speed data transfer and autonomous vehicle driving were offered to the public through the IFoF-based DAS. A downlink throughput of ~1 Gb/s and uplink throughput of ~200 Mb/s were achieved in the DAS-deployed area. We also present an IFoF-based 5G mobile fronthaul that can overcome the bandwidth bottleneck in RANs. We performed real-time transmission of mmWave-based 5G wireless access networks using the IFoF-based mobile fronthaul. The real-time downlink throughput achieved per 5G terminal was approximately 9 Gb/s, when using a 4 × 4 MIMO configuration. An outdoor demonstration was performed to verify the technical feasibility of the 5G fronthaul based on IFoF technology. When moving the 5G terminal between remote radio heads at a speed less than 60 km/h, 5G mobile broadband services could be provided with real-time throughput more than 5 Gb/s. Thus, we confirmed that the IFoF technology was capable of supporting RANs for mmWave-based 5G networks and providing real-time multi-Gb mobile services.
15 June 2014 in Photonic Network Communications
22 May 2019 in Journal of Lightwave Technology
In this study, we demonstrate fifth-generation (5G) trial services using intermediate frequency-over-fiber (IFoF) based distributed antenna system (DAS) implemented in a 28-GHz millimeter-wave (mmWave) during Pyeongchang Winter Olympics. To extend mmWave-based 5G wireless coverage, IFoF-based DAS with 2 × 2 multiple-input multiple-output (MIMO) configuration is presented. Error vector magnitude (EVM) measurements of the 5G signal on the IF and mmWave bands are performed for both downlink and uplink transmissions over 5-km single mode fiber. The experimental results confirm that the minimum requirement for 5G signals, defined by the technical specification of the third generation partnership project, are satisfied by EVMs less than 9%. In addition, the developed IFoF-based DAS that supports 5G mobile service using 28-GHz mmWave was deployed in the city of Pyeongchang, during Winter Olympics. An ultra-high speed 5G data service was offered to the general public for 5G trial demonstration. The reference signals received power and data throughput of the 5G handset are measured while moving in a DAS section and 5G connected car section. We confirm that the downlink throughput of ~1 Gb/s and uplink throughput of ~200 Mb/s are achieved for the 5G trial service area in which an IFoF based DAS is deployed. We also successfully demonstrate the 5G connected car service, which is one of the 5G key services, through deployed IFoF-based DAS. At the intersection of baseband unit (BBU) and DAS deployed sections, a seamless handover is performed to smoothly support 5G-based autonomous driving service.
1 December 2015 in ETRI Journal
We demonstrate a next-generation high-capacity mobile fronthaul based on radio over fiber (RoF) technology, which links between a digital unit and a radio unit supporting two frequency assignments and multiple input, multiple output antennas. To confirm the technical feasibility of a mobile fronthaul, we experimentally investigate its down- and uplink end-to-end performances including the optical and radio frequency (RF) signal path. Frequency-dependent performance deviations, error vector magnitude variations, overall system performance variations caused by optical to electrical conversion, and intermediate frequency to RF conversions are examined. Experimental verifications on multiple LTE uplink signals are performed for the first time. We also demonstrate several commercial mobile Internet services, YouTube video streaming, and file transfers using off-the-shelf mobile devices, through a mobile fronthaul based on RoF.
1 March 2001 in ETRI Journal
The performance of a long wavelength-band erbium-doped fiber amplifier (L-band EDFA) using 1530nm-band pumping has been studied. A 1530nm-band pump source is built using a tunable light source and two C-band EDFAs in cascaded configuration, which is able to deliver a maximum output power of 23dBm. Gain coefficient and noise figure (NF) of the L-band EDFA are measured for pump wavelengths between 1530nm and 1560nm. The gain coefficient with a 1545nm pump is more than twice as large as with a 1480nm pump. It indicates that the L-band EDFA consumes low power. The noise figure of 1530nm pump is 6.36dB at worst, which is 0.75dB higher than that of 1480nm pumped EDFA. The optimum pump wavelength range to obtain high gain and low NF in the 1530nm band appears to be between 1530nm and 1540nm. Gain spectra as a function of a pump wavelength have bandwidth of more than 10nm so that a broadband pump source can be used as 1530nm-band pump. The L-band EDFA is also tested for WDM signals. Flat Gain bandwidth is 32nm from 1571.5 to 1603.5nm within 1dB excursion at input signal of –10dBm/ch. These results demonstrate that 1530nm-band pump can be used as a new efficient pump source for L-band EDFAs.