Quantifying the emissions of per- and polyfluoroalkyl substances (PFAS) from Australian wastewater treatment plants (WWTP) is of high importance due to potential impacts on receiving aquatic ecosystems. The new Australian PFAS National Environmental Management Plan recommends 0.23 ng L-1 of PFOS as the guideline value for 99% species protection for aquatic systems. In this study, 21 PFAS from four classes were measured in WWTP solid and aqueous samples from 19 Australian WWTPs. The mean ∑21PFAS was 110 ng L-1 (median: 80 ng L-1; range: 9.3-520 ng L-1) in aqueous samples and 34 ng g-1 dw (median: 12 ng g-1 dw; range: 2.0-130 ng g-1 dw) in WWTP solids. Similar to WWTPs worldwide, perfluorocarboxylic acids were generally higher in effluent, compared to influent. Partitioning to solids within WWTPs increased with increasing fluoroalkyl chain length from 0.05 to 1.22 log units. Many PFAS were highly correlated, and PCA analysis showed strong associations between two groups: odd chained PFCAs, PFHxA and PFSAs; and 6:2 FTS with daily inflow volume and the proportion of trade waste accepted by WWTPs (as % of typical dry inflow). The compounds PFPeA, PFHxA, PFHpA, PFOA, PFNA, and PFDA increased significantly between influent and final effluent. The compounds 6:2 FTS and 8:2 FTS were quantified and F-53B detected and reported in Australian WWTP matrices. The compound 6:2 FTS was an important contributor to PFAS emissions in the studied Australian WWTPs, supporting the need for future research on its sources (including precursor degradation), environmental fate and impact in Australian aquatic environments receiving WWTP effluent.
18 September 2014 in Ecological Management & Restoration
In this work, we investigated the transport and burial of triclosan and its methylated derivative, in surface sediments near the mouth of Barker Inlet in South Australia. The most likely source of this commonly used bactericide to the area is a wastewater outfall discharging at the confluence of the inlet with marine waters. Triclosan was detected in all samples, at concentrations (5–27 μg kg−1) comparable to values found in other surface sediments under the influence of marine wastewater outfalls. Its dispersal was closely associated with fine and organic-rich fractions of the sediments. Methyl-triclosan was detected in approximately half of the samples at concentrations <11 μg kg−1. The occurrence of this compound was linked to both wastewater discharges and biological methylation of the parent compound. Wastewater-borne methyl-triclosan had a smaller spatial footprint than triclosan and was mostly deposited in close proximity to the outfall. In situmethylation of triclosan likely occurs at deeper depositional sites, whereas the absence of methyl-triclosan from shallower sediments was potentially explained by photodegradation of the parent compound. Based on partition equilibrium, a concentration of triclosan in the order of 1 μg L−1 was estimated in sediment porewaters, a value lower than the threshold reported for harmful effects to occur in the couple of species of marine phytoplankton investigated to date. Methyl-triclosan presents a greater potential for bioaccumulation than triclosan, but the implications of its occurrence to aquatic ecosystem health are difficult to predict given the lack of ecotoxicological data in the current literature.
Striving towards a circular economy, the application of treated sewage sludge (biosolids) to land is an opportunity to improve the condition of the soil and add essential nutrients, in turn reducing the need for fertilisers. However, there is an increasing concern about microplastic (MP) contamination of biosolids and their transport to terrestrial ecosystems. In Australia, agriculture is the largest biosolids end-user, however, there is limited understanding of MPs in Australian biosolids. Also, while the method to isolate MPs from biosolid is established, a need to extract and analyse MPs more efficiently is still pressing. In this study, we comprehensively quantified and characterised MPs in 146 biosolids samples collected from thirteen wastewater treatment plants (WWTPs) including different seasons. We have optimised an oxidative-enzymatic purification method to overcome current limitations for MP identification in complex samples and accurately report MPs in biosolids. This method enabled removal of >93 % of dry weight of organic material and greatly facilitated the MPs instrumental analysis. The concentration of MPs (>20 µm) in all biosolids samples ranged from 11 to 150 MPs/g dry weight. Abundance of MPs was affected by seasons with higher abundance of MPs usually found during cold and wet seasons. Despite seasonal variations, polyethylene terephthalate, polyurethane and polymethyl methacrylate were the most abundant polymers. Smaller MPs (20 to 200 µm) comprised >70 % of all detected MPs with a clear negative linear relationship observed between MP size and abundance. Per capita concentration of MPs in biosolids across all studied WWTPs was 0.7 to 21 g MPs per person per year. Therefore, biosolids are an important sink and source of MPs to agroecosystems, emphasising the need to more comprehensively understand the fate, impact and risks associated with MPs on agricultural soils.
1 February 2019 in Science of The Total Environment
The upper Spencer Gulf in South Australia hosts the world's largest single stream Pb-Zn smelter, which has caused environmental and health issues related to elevated metal concentrations in the surrounding environment. The area also has extensive seagrass meadows, occupying >4000 km2. We reconstructed the fluxes of heavy metals over the last ~3000 years through a multi-parameter study of the soil archives formed by the seagrass Posidonia australis. Pb, Zn and Cd concentrations increased up to 9-fold following the onset of smelter operations in the 1880s, and the stable Pb isotopic signatures confirmed the smelter has been the main source of lead pollution in the seagrass soils until present. Preliminary estimates suggest that over the past 15 years seagrass meadows within 70 km2 of the smelter accumulated ~7-15% of the smelter emissions in their soils. Here we demonstrate that seagrass meadows act as pollution filters and sinks while their soils provide a record of environmental conditions, allowing baseline conditions to be identified and revealing the time-course of environmental change.
10 September 2024 in Environmental Science & Technology