Giuseppina Massaro

Giuseppina Massaro

Auto-generated profile, based on publicly available information

Giuseppina Massaro

Department of Chemistry, Biology and Biotechnology, University of Perugia, Via Elce di Sotto, 8, 06123 Perugia, Italy

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2013 in Photochemical & Photobiological Sciences
Verified
Journal Article
Closed access
PDF file
Marta PenconiMarta Penconi
Marta Penconi
Pier Luigi GentiliPier Luigi Gentili
Pier Luigi Gentili
GMGiuseppina Massaro
Giuseppina Massaro
FEFausto Elisei
Fausto Elisei
FOFausto Ortica
Fausto Ortica
The triplet–triplet annihilation based up-conversion process, involving a platinum octaethyl-porphyrin (PtOEP) as a sensitizer and tetraphenyl-pyrene (TPPy) as an emitter, has been investigated in homogeneous solutions of toluene, bromobenzene and anisole, and oil-in-water microemulsions of the TX-100 surfactant, where toluene constitutes the non-polar phase. In homogeneous solutions, the highest up-conversion quantum yield (of the order of 20%) has been achieved in toluene, being the solvent that has the lowest viscosity among those explored. The up-conversion emission from the PtOEP–TPPy pair has been then investigated in a toluene based oil-in-water microemulsion at three different concentrations of the solutes, showing quantum yields up to the order of 1%, under the same irradiation conditions, but different deoxygenating procedures. The results herein reported might represent a good starting point for a future investigation in microheterogeneous systems. An optimization of the microemulsion composition, in terms of surfactant, co-surfactant and toluene concentrations, could allow us to increase the sensitizer and emitter concentrations and set up the best operative conditions to obtain even higher up-conversion efficiencies.

21 January 2016 in Chemistry of Materials
Verified
Journal Article
Closed access
GMGiuseppina Massaro
Giuseppina Massaro
JHJordi Hernando
Jordi Hernando
DRDaniel Ruiz-Molina
Daniel Ruiz-Molina
CRClaudio Roscini
Claudio Roscini
LLLoredana Latterini
Loredana Latterini

4 June 2016 in Nanomaterials
Verified
Journal Article
Open access
PDF file
LTLuigi Tarpani
Luigi Tarpani
FMFrancesco Morena
Francesco Morena
MGMarta Gambucci
Marta Gambucci
GZGiulia Zampini
Giulia Zampini
GMGiuseppina Massaro
Giuseppina Massaro
LLLoredana Latterini
Loredana Latterini
The preparation of tailored nanomaterials able to support cell growth and viability is mandatory for tissue engineering applications. In the present work, silica nanoparticles were prepared by a sol-gel procedure and were then functionalized by condensation of amino groups and by adsorption of silver nanoparticles. Transmission electron microscopy (TEM) imaging was used to establish the morphology and the average dimensions of about 130 nm, which were not affected by the functionalization. The three silica samples were deposited (1 mg/mL) on cover glasses, which were used as a substrate to culture adult human bone marrow-mesenchymal stem cells (hBM-MSCs) and human adipose-derived stem cells (hASCs). The good cell viability over the different silica surfaces was evaluated by monitoring the mitochondrial dehydrogenase activity. The analysis of the morphological parameters (aspect ratio, cell length, and nuclear shape Index) yielded information about the interactions of stem cells with the surface of three different nanoparticles. The data are discussed in terms of chemical properties of the surface of silica nanoparticles.

12 October 2017 in ChemPhotoChem
Verified
Journal Article
Closed access
PDF file
GZGiulia Zampini
Giulia Zampini
LTLuigi Tarpani
Luigi Tarpani
GMGiuseppina Massaro
Giuseppina Massaro
MGMarta Gambucci
Marta Gambucci
ANAndrea Nicoziani
Andrea Nicoziani
LLLoredana Latterini
Loredana Latterini

1 July 2017 in Microporous and Mesoporous Materials
Verified
Journal Article
Closed access
GMGiuseppina Massaro
Giuseppina Massaro
Pier Luigi GentiliPier Luigi Gentili
Pier Luigi Gentili
Valeria AmbrogiValeria Ambrogi
Valeria Ambrogi
MNMorena Nocchetti
Morena Nocchetti
MFMarmottini Fabio
Marmottini Fabio
LLLoredana Latterini
Loredana Latterini

15 May 2018 in Dalton Transactions
Verified
Journal Article
Closed access
PDF file
LLLoredana Latterini
Loredana Latterini
GMG. Massaro
G. Massaro
Marta PenconiMarta Penconi
Marta Penconi
Pier Luigi GentiliPier Luigi Gentili
Pier Luigi Gentili
CRClaudio Roscini
Claudio Roscini
FOF. Ortica
F. Ortica
Radiation upconversion can be an elegant and efficient strategy to minimize waste in energy harvesting and storage processes. The upconversion based on triplet–triplet annihilation processes of molecular dyes is a very versatile approach, but it requires a systematic photophysical characterization of the systems to optimize the upconversion yields and develop materials for technological applications. This paper represents an overview of the work carried out in our laboratories for the study and characterization of a molecular dye pair, 2,3,7,8,12,13,17,18-octaethyl-21H,23H-porphyrin platinum(II) (PtOEP) and 1,3,6,8-tetraphenylpyrene (TPPy), suitable as the sensitizer and emitter, respectively, in a triplet–triplet annihilation based upconversion process. The investigation has been carried out in various media with increasing complexity. First, we used the dye pair to characterize the UC-efficiencies in homogeneous solvents of different viscosities and in oil-in-water microemulsions; then we explored the possibility to achieve upconversion in solid materials, like nanostructured silica matrices and liquid filled microcapsules. The possibility to achieve upconversion emission even in confined and rigid media has been confirmed and can inspire further applications of the process.